Boilers and Power Plant
Boilers, steam and water, combustion, thermic fluid heaters, turbines and plant performance.
Efficiency, losses, fuel saving, output and sizing, blowdown, start-up and operation.
- Boiler Efficiency, Solid and Liquid Fuels (ASME PTC 4)
- Boiler Blowdown Rate (TDS Balance)
- Blowdown Heat Recovery (Flash Vessel and Cooler)
- Boiler Banking (Hot Standby) Fuel Loss
- Boiler Capacity for a Sugar Mill
Tube metal temperature and stress, creep and oxide life, drums, natural circulation, two-phase flow and tube vibration.
- Boiler Circulation Ratio, Downcomer and Riser Velocity
- Boiler Drum Flash Steam on Pressure Drop (Swell)
- Boiler Tube Metal Temperature from Heat Flux
- Boiler Water Content (Drum, Tubes, Headers)
- Creep Life Fraction by Robinson's Rule
Furnace radiation and heat release, superheaters, economisers, air preheaters and cold-end corrosion.
- Air Heater Cold-End Average Temperature vs Acid Dew Point
- Air Heater Leakage from O₂ Readings
- Air Preheater Heat Balance (Air Outlet Temperature)
- Air Preheater X-Ratio and Gas- and Air-Side Effectiveness
- Cold-End Metal Temperature vs Acid Dew Point
Bubbling and circulating fluidised beds: regimes, voidage, solids inventory, heat transfer, sorbents and furnace sizing.
- AFBC Bed Area from Superficial Velocity
- AFBC Bed Heat Balance and In-Bed Tube Duty
- Bed Inventory and Height from Bed Pressure Drop
- CFB Furnace Cross-Section: Grate Heat Release and Velocity
- CFB Furnace Membrane Wall Area and Heat Absorbed
Heat recovery steam generators, exhaust and waste heat recovery, ORC and cogeneration utilisation.
- Absorption Chilling from Exhaust or Hot Water
- Air Compressor Heat Recovery to Water
- Cogeneration vs Power Only: Energy Utilisation
- Exhaust Gas Heater for Hot Water or Thermic Fluid
- Gas Engine Heat Recovery: Exhaust Steam and Jacket Hot Water
Properties of water and steam, flash steam, desuperheating, deaeration and feedwater heating.
- Steam Properties (IAPWS-IF97)
- Flash Steam from Condensate or Blowdown
- Desuperheater Spray Water Flow
- Saturation Temperature and Pressure of Steam
- Deaerator Heating Steam Consumption
Stoichiometry, heating values, excess air, flue gas composition and properties.
- Combustion of Solid and Liquid Fuels
- Adiabatic Flame Temperature Calculator
- Atomising Steam Consumption and Heat Loss
- Biomass Ash Alkali Index (Fouling Tendency)
- Bomb Calorimeter Gross Calorific Value
Heater duty, thermal oil flow, film temperature and expansion tanks.
- Thermic Fluid Against Steam Heating: Annual Running Cost
- Thermic Fluid Circulation Flow and Velocity
- Thermic Fluid Expansion Tank Volume
- Thermic Fluid Film Temperature (Dittus–Boelter)
- Thermic Fluid Heater Coil Pressure Drop and Pump Power
Steam turbine expansion, steam rate, Rankine and cogeneration cycles.
- Back-Pressure Turbine: Power vs Exhaust Pressure
- Back-Pressure vs Extraction-Condensing Turbine Power
- Carnot Efficiency of a Heat Engine
- Cogeneration Heat-to-Power Ratio, EUF and PES
- Combined Cycle Efficiency and Power Split
Condenser duty and vacuum, cooling water flow, tower range and approach.
- Air-Cooled Condenser (ACC) Duty and Air Flow
- Condenser Air In-Leakage from a Vacuum Rate-of-Rise Test
- Condenser Air Removal: Vapour Load and Suction Volume
- Condenser Back Pressure at Other Cooling Water Conditions
- Condenser Surface Area from LMTD
Heat rate, plant efficiency, auxiliary power and cost of steam.
- Boiler House Auxiliary Energy per Tonne of Steam (Period Totals)
- Boiler House Auxiliary Power from Drive Loads
- Boiler Load Factor and Capacity Utilisation
- CO₂ per Tonne of Steam (Fossil and Biogenic)
- Cogeneration Export Revenue (Season and Off-Season)
Emission corrections, CO₂ factors, stack draught, diameter and dew points.
- Bag Filter Sizing (Cloth Area and Number of Bags)
- Balanced Draught: ID Fan Pressure Required
- Chimney Draught, Hot Gas Column and Chimney Efficiency
- CO₂ Emission Factor of a Fuel
- Cyclone Cut Size and Collection Efficiency (Lapple)
Coal, biomass and ash quantities, storage and conveying.
- Ash Fusion Temperature from Ash Analysis
- Ash Generation Rate (Bottom Ash and Fly Ash)
- Ash Sluicing: Water, Slurry Flow and Pump Power
- Biomass Fuel Storage: Mass, Volume and Energy for a Number of Days
- Bucket Elevator Capacity
Softening, demineralisation, dosing and cycles of concentration.
- Blowdown Flash and Quench Water to a Discharge Temperature
- Boiler Blowdown Rate from Water Analysis
- Boiler Blowdown Set by Water Limits (TDS, Silica, Alkalinity)
- Boiler Chemical Cleaning: Acid for a Magnetite Deposit
- Boiler Chemical Consumption and Cost per Tonne of Steam