Worked example
Example: Two conditions. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Hours at condition 1 | 60,000 h |
| Rupture life at condition 1 | 400,000 h |
| Hours at condition 2 | 20,000 h |
| Rupture life at condition 2 | 120,000 h |
| Hours at condition 3 | 0 h |
| Rupture life at condition 3 | 1,000,000 h |
| Hours at condition 4 | 0 h |
| Rupture life at condition 4 | 1,000,000 h |
Applying the formula below gives:
| Result | Value |
|---|---|
| Life fraction used Σ t/t_r | 31.667 % |
| Life fraction remaining | 68.333 % |
| Remaining hours at condition 1 | 273,333 h |
Open this example in the calculator and change any input.
Formula
\(D = \sum_i \frac{t_i}{t_{r,i}}, \quad t_{rem} = \max(0,\ 1 - D)\,t_{r,1}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(t_1\) | Hours at condition 1 | s |
| \(t_{r,1}\) | Rupture life at condition 1 | s |
| \(t_2\) | Hours at condition 2 | s |
| \(t_{r,2}\) | Rupture life at condition 2 | s |
| \(t_3\) | Hours at condition 3 | s |
| \(t_{r,3}\) | Rupture life at condition 3 | s |
| \(t_4\) | Hours at condition 4 | s |
| \(t_{r,4}\) | Rupture life at condition 4 | s |
| \(D\) | Life fraction used Σ t/t_r | - |
| \(1 − D\) | Life fraction remaining | - |
| \(t_{rem}\) | Remaining hours at condition 1 | s |
Method and standards
Robinson's linear life-fraction rule (E. L. Robinson, Trans. ASME 74, 1952): creep damage is the sum of the time at each condition over the rupture life at that condition, and failure is predicted when the sum reaches 1. The remaining hours are at condition 1 and are shown as zero once the sum reaches 1; the remaining fraction is then negative.
Where it is used
- Remaining life assessment.
- Overheating incident reviews.
Common mistakes
- Rupture life at design rather than actual temperature.
Assumptions and limits
- Linear damage summation.
- Remaining hours assume future operation at condition 1; if the tube will run at another condition, put that condition first.
References
- Robinson's linear life-fraction rule D = Σ t_i/t_r
- i; rupture lives from the user's material data (e.g. via the Larson–Miller parameter)
Questions and answers
What is Robinson's rule?
Creep damage adds up as the sum of time spent at each condition divided by the rupture time at that condition.
Where do rupture lives come from?
The material's stress-rupture data at the metal temperature and hoop stress; the Larson–Miller calculator converts between them.
Why do a few hot hours matter?
Rupture life falls steeply with temperature: overheating periods dominate the sum.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.