FireCADCalc

Calculators by equipment

Everything about one piece of plant equipment in one place.

Boiler 312

Every boiler calculator in one place: efficiency, losses, combustion, blowdown, output and cold-end corrosion.

Economiser and air preheater 34

Economiser and air preheater heat balances, air heater leakage, condensing economisers and the fuel saved by heat recovery.

Steam turbine 33

Steam turbine power, isentropic efficiency, steam rate, heat rate, extraction balance and Rankine cycle calculators.

Condenser and cooling tower 22

Surface and air-cooled condenser duty, vacuum, area and tubes, cooling water flow, and cooling tower performance and water balance.

Water treatment plant 23

Softener, DM plant and RO sizing, chemical dosing (oxygen scavenger, phosphate, amine), hardness conversions and blowdown from water limits.

Fuel oil and gas system 31

Fuel oil heating, viscosity and tank heating, atomising steam, gas train flow, gas line pressure drop, Wobbe index and LPG vaporisers.

Thermic fluid heater 5

Thermic fluid (hot oil) heater circulation flow, film temperature, expansion tank volume and efficiency.

Deaerator and feedwater system 17

Deaerator heating steam, feedwater heater extraction, feedwater properties and blowdown recovery calculators.

Desuperheater and PRDS 11

Spray water flow, outlet conditions and steam properties for desuperheaters and pressure reducing stations.

Flash vessel and condensate 11

Flash steam from condensate and blowdown, flash vessel recovery and saturation conditions.

Burner and furnace 58

Combustion air, flue gas quantity and composition, excess air and heating value calculators for burners and furnaces.

Stack and chimney 40

Stack loss, flue gas properties, dew point and draught calculators for stacks and chimneys.

Pump 56

Pump power, NPSH available, affinity laws and suction and discharge line losses for feed, make-up, transfer and cooling water pumps.

Fan and blower 51

Fan power, fan laws, air density and duct calculators for forced draught, induced draught, primary and secondary air fans and blowers.

Dust collector (ESP, bag filter, cyclone) 15

Electrostatic precipitator, bag filter and cyclone calculators with the dust load and emission they lead to, for boilers and furnaces.

Electric motor 46

Full-load current, input power and efficiency calculators for electric motors.

Tank and drum 52

Tank volume, liquid level and geometry calculators for vertical and horizontal storage tanks and drums.

Air compressor and receiver 13

Compressor power, discharge temperature, receiver size, leak cost and free air delivery calculators for compressed-air systems.

Air conditioning and chillers 19

Psychrometric, cooling-load, chilled-water and refrigeration calculators for air handling units, chillers and coolers.

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.