Worked example
Example: 70 bar, 25 m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Drum pressure (absolute) | 70.000 bar |
| Height of the heated riser above the downcomer bottom | 25.000 m |
| Mean riser quality | 5.0000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Downcomer water density (saturated) | 739.72 kg/m³ |
| Mean riser density (homogeneous) | 376.90 kg/m³ |
| Driving head | 88.953 kPa |
Open this example in the calculator and change any input.
Formula
\(\rho_r = \left(\frac{\bar x}{\rho_v} + \frac{1-\bar x}{\rho_l}\right)^{-1}, \quad \Delta p_d = g H (\rho_l - \rho_r)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(p_d\) | Drum pressure (absolute) | Pa |
| \(H\) | Height of the heated riser above the downcomer bottom | m |
| \(\bar x\) | Mean riser quality | - |
| \(\rho_l\) | Downcomer water density (saturated) | kg/m³ |
| \(\rho_r\) | Mean riser density (homogeneous) | kg/m³ |
| \(\Delta p_d\) | Driving head | Pa |
Method and standards
Hydrostatics of the loop: the driving head is g H times the density difference between the saturated water in the downcomer and the two-phase riser mixture, with the riser density from the homogeneous (no-slip) model at the mean quality and IAPWS-IF97 saturated densities.
Where it is used
- Circulation design checks.
Common mistakes
- Exit quality used as mean.
Assumptions and limits
- Saturated downcomer water.
- Homogeneous (no-slip) riser density at one mean quality: slip and the averaging of density along the riser both raise the true riser density, so the head is overstated (an upper bound).
References
- Δp = g H (ρ_l − ρ_r) with homogeneous riser density; IAPWS-IF97 saturated densities
Questions and answers
Why does circulation weaken at high pressure?
Water and steam densities converge, so the density difference shrinks.
Homogeneous or slip?
Slip raises riser density and lowers the head; the homogeneous value is an upper bound.
Mean riser quality?
Roughly half the riser exit quality for uniform heating. Because the mixture density is not linear in quality, the true length-averaged riser density is higher than the density at that mean quality, so the head found this way is an upper bound.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.