Worked example
Example: Economiser span 1.5 m pinned. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Span between supports | 1.5000 m |
| End conditions | Pinned–pinned (λ = π) |
| Tube outside diameter | 50.800 mm |
| Tube inside diameter | 44.200 mm |
| Young's modulus at temperature | 190.00 GPa |
| Tube material density | 7,850.0 kg/m³ |
| Contents and added mass per metre | 1.5000 kg/m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Second moment of area | 13.956 cm⁴ |
| Total mass per metre | 5.3657 kg/m |
| First natural frequency | 49.077 Hz |
Open this example in the calculator and change any input.
Formula
\(f_n = \frac{\lambda^2}{2\pi L^2}\sqrt{\frac{EI}{m}}, \quad I = \frac{\pi(d_o^4 - d_i^4)}{64}, \quad m = \rho_t\frac{\pi(d_o^2 - d_i^2)}{4} + m_a\)
\(\lambda = \pi\ (\text{pinned–pinned}), \quad 3.9266\ (\text{clamped–pinned}), \quad 4.7300\ (\text{clamped–clamped})\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(L\) | Span between supports | m |
| \(\text{ends}\) | End conditions | - |
| \(\lambda\) | first-mode eigenvalue for the end conditions | - |
| \(d_o\) | Tube outside diameter | m |
| \(d_i\) | Tube inside diameter | m |
| \(E\) | Young's modulus at temperature | Pa |
| \(\rho_t\) | Tube material density | kg/m³ |
| \(m_a\) | Contents and added mass per metre | kg/m |
| \(I\) | Second moment of area | m⁴ |
| \(m\) | Total mass per metre | kg/m |
| \(f_n\) | First natural frequency | 1/s |
Method and standards
Euler–Bernoulli beam theory for the first bending mode of a uniform span, with the eigenvalues for the chosen end conditions as tabulated by Blevins; the mass per metre is the tube metal plus the contents and added mass you enter.
Where it is used
- Tube bank and economiser vibration checks.
- Support spacing.
Common mistakes
- Cold modulus at hot temperature.
Assumptions and limits
- Uniform beam, small deflection.
- The added mass is your input: contents ρ_in π d_i²/4 plus about C_m ρ_out π d_o²/4 for the fluid outside (C_m near 1 for an isolated tube, higher in a close bundle); for gas outside it is negligible.
References
- Euler–Bernoulli beam f = (λ²/2πL²)√(EI/m) with λ = π
- 3.9266
- 4.7300 (Blevins, Formulas for Natural Frequency and Mode Shape)
Questions and answers
What is added mass?
Fluid around the tube moves with it; for gas it is small, for liquid it can be large.
Which end condition?
Supports usually lie between pinned and clamped: check both.
Why does it matter?
Resonance with vortex shedding or duct acoustics damages tubes and baffles.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.