Worked example
Example: Rice husk. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Ash % fuel (as fired) | 18.000 % |
| K₂O % ash | 2.0000 % |
| Na₂O % ash | 0.50000 % |
| Fuel GCV (as fired) | 13,500 kJ/kg |
Applying the formula below gives:
| Result | Value |
|---|---|
| Alkali index (kg alkali oxides per GJ) | 0.33333 kg/GJ |
Open this example in the calculator and change any input.
Formula
\(AI = \frac{A\,(K_2O + Na_2O)}{GCV}\)
Fouling probable for \(0.17 < AI \le 0.34\) kg/GJ; virtually certain above 0.34 kg/GJ.
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(A\) | Ash % fuel (as fired) | - |
| \(K_2O\) | K₂O % ash | - |
| \(Na_2O\) | Na₂O % ash | - |
| \(GCV\) | Fuel GCV (as fired) | J/kg |
| \(AI\) | Alkali index, shown in kg of alkali oxides per GJ (1 kg/GJ = 10⁻⁹ kg/J) | kg/J |
Method and standards
The alkali index of Miles, Miles, Baxter, Bryers, Jenkins and Oden, Alkali Deposits Found in Biomass Power Plants (NREL, 1995–1996): the mass of K₂O + Na₂O brought in per GJ of fuel heat, with their thresholds of 0.17 kg/GJ (fouling probable) and 0.34 kg/GJ (fouling and slagging virtually certain).
Where it is used
- Fuel selection.
- Boiler design for biomass and slop.
Common mistakes
- Ash % of dry fuel with as-fired GCV.
Assumptions and limits
- Same basis for ash and GCV (both as fired, or both dry); the index is per GJ of gross (higher) heating value. The code cannot check the basis.
References
- Miles et al. (1995/1996)
- alkali deposits in biomass power plants (NREL): AI = (K₂O + Na₂O) in kg per GJ of fuel; thresholds 0.17 and 0.34 kg/GJ
Questions and answers
Why alkali?
Potassium and sodium form low-melting deposits on superheaters and the furnace.
Bagasse vs straw?
Bagasse is usually moderate; straw, husk with high potassium and slop are severe.
What to do when it is high?
Lower furnace exit temperature, wider tube spacing, more soot blowing, or blending.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.