Worked example
Example: 12 % CO₂, 7 % O₂, 0.5 % CO. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Carbon dioxide (dry, by volume) | 12.000 % |
| Oxygen (dry, by volume) | 7.0000 % |
| Carbon monoxide (dry, by volume) | 0.50000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Nitrogen by difference | 80.500 % |
| Free oxygen corrected for CO (O₂ − CO/2) | 6.7500 % |
| Excess air | 46.283 % |
| Air factor (actual / theoretical air) | 1.4628 |
Open this example in the calculator and change any input.
Formula
\(N_2 = 1 - CO_2 - O_2 - CO\)
\(EA = \frac{O_2 - CO/2}{k\, N_2 - (O_2 - CO/2)}, \quad k = \frac{0.2095}{0.7905}\)
\(\lambda = 1 + EA\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(CO_2\) | Carbon dioxide (dry, by volume) | - |
| \(O_2\) | Oxygen (dry, by volume) | - |
| \(CO\) | Carbon monoxide (dry, by volume) | - |
| \(N_2\) | Nitrogen by difference | - |
| \(O_{2,x}\) | Free oxygen corrected for CO (O₂ − CO/2) | - |
| \(EA\) | Excess air | - |
| \(\lambda\) | Air factor (actual / theoretical air) | - |
Method and standards
All nitrogen in the dry flue gas came from the air; the oxygen supplied is k N₂, where k is the oxygen-to-atmospheric-nitrogen ratio of air (ASME PTC 4 composition).
Worked example
Orsat analysis of flue gas: CO₂ 12 %, O₂ 7 %, CO 0.5 %.
- N₂ = 100 − 12 − 7 − 0.5 = 80.5 %
- Oxygen supplied with the air = 0.265 × 80.5 = 21.33 %; free oxygen = 7 − 0.5/2 = 6.75 %
- Excess air = 6.75 / (21.33 − 6.75) = 0.463, so 46 %
Where it is used
- Boiler attendant and operator examinations.
- Tuning burners from an Orsat or portable analyser reading.
- Checking a combustion test.
Common mistakes
- Using wet-basis analyser readings.
- Ignoring CO.
- Using 21/79 = 0.266 and 0.265 interchangeably for precise work (small difference).
Assumptions and limits
- Dry flue gas; fuel nitrogen neglected.
- Argon is counted with the nitrogen.
- Unburnt hydrogen and hydrocarbons are not measured by an Orsat and fall into the nitrogen by difference; SO₂ is absorbed with the CO₂. Both slightly distort the result for fuels high in sulphur or with incomplete combustion.
- An analysis with no CO₂ and no CO is rejected as not a flue gas.
References
- Nitrogen balance on the dry flue gas (textbook)
- ASME PTC 4-2013 air composition (20.95 % O₂)
Questions and answers
What excess air gives 12 % CO₂, 7 % O₂ and 0.5 % CO?
Nitrogen by difference 80.5 %; free oxygen 7 − 0.25 = 6.75 %; excess air = 6.75 / (0.265 × 80.5 − 6.75) = 46 %.
Why subtract half the CO?
Each volume of CO still needs half a volume of oxygen to burn; that oxygen is not really excess.
When is the nitrogen method wrong?
When the fuel itself holds much nitrogen (some process gases): that nitrogen is not from air.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.