FireCADCalc

Shaft Torque from Power and Speed (and Shaft Size)

Torque on a shaft from power and speed (T = P/ω), and the least solid shaft diameter for an allowable shear stress in pure torsion.

PumpFan and blowerElectric motor

Inputs

Examples: 75 kW at 1480 rpm, 40 MPa, factor 1.55.5 kW at 960 rpm, 30 MPa, 1.25500 kW at 300 rpm, 50 MPa, 1.75

From your design code or a safety factor on the material's shear yield; keyways reduce the allowable stress.

Results

Pure torsion only: add bending from pulleys, gears or overhung loads by a combined-stress method before choosing the shaft.

Torque483.92N·m
Design torque with the service factor725.88N·m
Least solid shaft diameter45.212mm
Angular speed154.99rad/s

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 75 kW at 1480 rpm, 40 MPa, factor 1.5. The inputs, in the units selected above:

InputValue
Power transmitted75.000 kW
Shaft speed1,480.0 rpm
Allowable shear stress40.000 MPa
Service (shock) factor on torque1.5000 -

Applying the formula below gives:

ResultValue
Torque483.92 N·m
Design torque with the service factor725.88 N·m
Least solid shaft diameter45.212 mm
Angular speed154.99 rad/s

Open this example in the calculator and change any input.

Formula

\(\omega = 2\pi n \qquad T = \frac{P}{\omega} \qquad T_d = K\,T \qquad d_{min} = \sqrt[3]{\frac{16\,T_d}{\pi\,\tau_a}}\)

Variables

Symbol Meaning SI unit
\(P\) power W
\(n\) speed rev/s
\(\tau_a\) allowable shear stress Pa
\(K\) service factor –
\(T\) torque N·m
\(T_d\) design torque N·m
\(d_{min}\) least solid shaft diameter m
\(\omega\) angular speed rad/s

Method and standards

Power–torque relation and elastic torsion of a solid circular shaft.

Where it is used

  • Coupling and shaft sizing.
  • Motor and gearbox selection.
  • Checking key and shaft stresses.

Common mistakes

  • Using rpm without converting to rad/s.
  • Ignoring bending and keyway stress concentration.
  • No service factor for shock loads.

Assumptions and limits

  • Solid round shaft; pure torsion.

References

  • Torsion of a solid circular shaft

Questions and answers

What torque does 75 kW at 1480 rpm give?

484 N·m; with a service factor of 1.5 the design torque is 726 N·m and a solid shaft needs at least 45 mm at 40 MPa allowable shear.

How do I convert kW and rpm to N·m quickly?

T = 9549 × kW / rpm.

Is torsion alone enough?

No. Pulleys and gears add bending; use a combined-stress method.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.