Worked example
Example: 500 N·m, 250 mm drum, 270°, μ 0.3, 80/600 mm lever. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Braking torque needed | 500.00 N·m |
| Drum radius | 250.00 mm |
| Coefficient of friction | 0.30000 - |
| Angle of wrap | 270.00 ° |
| Distance from the lever pivot to the band's slack end | 80.000 mm |
| Lever length to the hand or actuator | 600.00 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Tension ratio e^{μθ} | 4.1112 |
| Tight-side tension | 2.6428 kN |
| Slack-side tension | 0.64284 kN |
| Force at the lever end (simple band brake, tight end at the pivot) | 0.085712 kN |
Open this example in the calculator and change any input.
Formula
\(\frac{T_1}{T_2} = e^{\mu\theta}, \quad T = (T_1 - T_2) r, \quad P = T_2\, \frac{a}{l}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(T\) | Braking torque needed | N·m |
| \(r\) | Drum radius | m |
| \(\mu\) | Coefficient of friction | - |
| \(\theta\) | Angle of wrap | rad |
| \(a\) | Distance from the lever pivot to the band's slack end | m |
| \(l\) | Lever length to the hand or actuator | m |
| \(T_1/T_2\) | Tension ratio e^{μθ} | - |
| \(T_1\) | Tight-side tension | N |
| \(T_2\) | Slack-side tension | N |
| \(P\) | Force at the lever end (simple band brake, tight end at the pivot) | N |
Method and standards
Capstan friction and lever moments.
Where it is used
- Winches and hoists.
- Machine design examinations.
Common mistakes
- Wrap angle in degrees in the exponent.
- Ignoring direction of rotation.
Assumptions and limits
- Simple band brake, one drum direction (tight end at the pivot).
- The band stress and the maximum lining pressure p_max = T₁/(b r) are not checked (the band width is not an input); check them for sizing.
References
- Capstan equation applied to band brakes (Shigley's Mechanical Engineering Design (Budynas and Nisbett), ch. 16)
Questions and answers
500 N·m on a 250 mm radius drum, 270° wrap, μ 0.3?
T₁/T₂ = 4.11; T₂ = 643 N, T₁ = 2643 N.
What force at the lever?
86 N with 80 mm and 600 mm arms.
Why does direction matter?
With the drum reversed the tight side moves to the lever end.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.