Worked example
Example: 20 kN at 300 mm, six bolts on 100 mm radius, M16. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Shear load on the group | 20.000 kN |
| Eccentricity of the load from the group centre | 300.00 mm |
| Number of bolts on the circle | 6.0000 - |
| Radius of the bolt circle | 100.00 mm |
| Bolt diameter in shear | 16.000 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Direct (primary) shear per bolt F/n | 3.3333 kN |
| Torsional (secondary) shear per bolt F e r/Σr² | 10.0000 kN |
| Largest resultant bolt force | 13.333 kN |
| Shear stress in that bolt | 66.315 MPa |
Open this example in the calculator and change any input.
Formula
\(F' = \frac{F}{n}, \quad F'' = \frac{F e\, r}{\sum r_i^2} = \frac{F e}{n r}, \quad F_{max} = \left|\vec F' + \vec F''\right|_{max}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(F\) | Shear load on the group | N |
| \(e\) | Eccentricity of the load from the group centre | m |
| \(n\) | Number of bolts on the circle | - |
| \(r\) | Radius of the bolt circle | m |
| \(d\) | Bolt diameter in shear | m |
| \(F'\) | Direct (primary) shear per bolt F/n | N |
| \(F''\) | Torsional (secondary) shear per bolt F e r/Σr² | N |
| \(F_{max}\) | Largest resultant bolt force | N |
| \(\tau\) | Shear stress in that bolt | Pa |
Method and standards
Elastic analysis of a bolt group.
Where it is used
- Brackets and crane connections.
- Machine design examinations.
Common mistakes
- Adding magnitudes without direction.
- Using bolt thread area for fitted bolts.
Assumptions and limits
- Equal bolts, rigid plates.
- Shear stress on the nominal (shank) area: if the threads lie in the shear plane use the root area, which gives a higher stress. The stress is not compared with an allowable.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 8 (shear joints with eccentric loading, elastic method)
Questions and answers
20 kN at 300 mm on six bolts on a 100 mm radius?
Direct 3333 N, torsional 10000 N per bolt; worst bolt about 13333 N where they add.
Why does eccentricity dominate?
The moment F e grows with the lever arm while direct shear is fixed.
Rectangular patterns?
Use Σr² of the actual bolt positions; this calculator covers circular patterns.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.