FireCADCalc

Spur Gear Contact Ratio and Interference Check

Contact ratio of a pair of standard spur gears from tooth numbers, module and pressure angle, and the minimum pinion teeth to avoid interference.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: 20/50, m 4, 20°14/40, m 3, 20° (interference)

Results

Centre distance140.00mm
Length of contact19.551mm
Contact ratio1.6557
Minimum pinion teeth to avoid interference14.634

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 20/50, m 4, 20°. The inputs, in the units selected above:

InputValue
Pinion teeth20.000 -
Gear teeth50.000 -
Module4.0000 mm
Pressure angle20.000 °
Addendum coefficient (1 for full depth)1.0000 -

Applying the formula below gives:

ResultValue
Centre distance140.00 mm
Length of contact19.552 mm
Contact ratio1.6558
Minimum pinion teeth to avoid interference14.637

Open this example in the calculator and change any input.

Formula

\(L_c = \sqrt{(r_1 + a)^2 - r_{b1}^2} + \sqrt{(r_2 + a)^2 - r_{b2}^2} - C\sin\phi, \quad m_c = \frac{L_c}{\pi m\cos\phi}\)

Variables

Symbol Meaning SI unit
\(z_1\) Pinion teeth -
\(z_2\) Gear teeth -
\(m\) Module m
\(\phi\) Pressure angle rad
\(k_a\) Addendum coefficient (1 for full depth) -
\(C\) Centre distance m
\(L_c\) Length of contact m
\(m_c\) Contact ratio -
\(z_{min}\) Minimum pinion teeth to avoid interference -

Method and standards

Involute geometry.

Where it is used

  • Gear pair design.
  • Checking a ratio change.

Common mistakes

  • Using pitch radii for addendum circles.
  • Ignoring profile shift.

Assumptions and limits

  • Standard involute gears at standard centre distance.
  • When interference occurs the contact length assumes full involute action, so the contact ratio is overstated.

References

  • Budynas and Nisbett
  • Shigley's Mechanical Engineering Design
  • 10th ed. (McGraw-Hill, 2015)
  • ch. 13 (contact ratio; interference)

Questions and answers

What does a contact ratio of 1.6 mean?

On average 1.6 pairs of teeth are in mesh: two pairs for 60 % of the time and one pair for 40 %.

Why do small pinions interfere?

Their teeth dip below the base circle where the involute does not exist; the mating tip digs into the flank.

What do the defaults represent?

A 20-tooth pinion and 50-tooth gear, 4 mm module, 20° full depth.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.