FireCADCalc

Pin Joint (Clevis) in Double Shear and Bearing

Shear stress in a clevis pin in double shear, bearing stress on the pin and eye, and the smallest pin diameter for allowable stresses.

Inputs

Examples: 50 kN, 25 mm pin, 30 mm eye120 kN, 40 mm pin, 40 mm eye8 kN, 12 mm pin, 10 mm eye

Results

Pin shear within the allowable.

Bearing on the eye within the allowable.

Bearing on the fork plates, bending of the pin and tear-out of the eye are separate checks.

Shear stress in the pin F/(2 π d²/4)50.930MPa
Bearing stress on the eye F/(d t)66.667MPa
Pin diameter needed for shear19.947mm
Pin diameter needed for bearing13.889mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 50 kN, 25 mm pin, 30 mm eye. The inputs, in the units selected above:

InputValue
Load on the joint50.000 kN
Pin diameter25.000 mm
Thickness of the eye (middle plate)30.000 mm
Allowable shear stress of the pin80.000 MPa
Allowable bearing stress120.00 MPa

Applying the formula below gives:

ResultValue
Shear stress in the pin F/(2 π d²/4)50.930 MPa
Bearing stress on the eye F/(d t)66.667 MPa
Pin diameter needed for shear19.947 mm
Pin diameter needed for bearing13.889 mm

Open this example in the calculator and change any input.

Formula

\(\tau = \frac{F}{2\,\pi d^2/4}, \quad \sigma_b = \frac{F}{d\, t}\)

Variables

Symbol Meaning SI unit
\(F\) Load on the joint N
\(d\) Pin diameter m
\(t\) Thickness of the eye (middle plate) m
\(\tau_a\) Allowable shear stress of the pin Pa
\(\sigma_{b,a}\) Allowable bearing stress Pa
\(\tau\) Shear stress in the pin F/(2 π d²/4) Pa
\(\sigma_b\) Bearing stress on the eye F/(d t) Pa
\(d_s\) Pin diameter needed for shear m
\(d_b\) Pin diameter needed for bearing m

Method and standards

Direct shear and bearing.

Where it is used

  • Linkages, cylinders and lifting gear.
  • Machine design examinations.

Common mistakes

  • Single-shear area for a clevis.
  • Ignoring eye tear-out.

Assumptions and limits

  • Static load; double shear with the eye as the middle plate.
  • Bearing on the fork plates, bending of the pin and tear-out of the eye are not checked.

References

  • Direct shear and projected-area bearing (textbook strength of materials)

Questions and answers

A 25 mm pin carrying 50 kN in double shear?

50.9 MPa shear; bearing on a 30 mm eye 66.7 MPa.

Why double shear?

The pin is cut on two planes, one each side of the middle plate.

What about bending?

Long pins in loose clevises bend; check them separately.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.