Worked example
Example: 6 mm wire, 45 mm mean diameter, 8 coils, 500 N. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Wire diameter | 6.0000 mm |
| Mean coil diameter | 45.000 mm |
| Number of active coils | 8.0000 - |
| Shear modulus of the wire | 79.300 GPa |
| Load | 500.00 N |
Applying the formula below gives:
| Result | Value |
|---|---|
| Spring rate | 17.622 N/mm |
| Spring index D/d | 7.5000 |
| Wahl stress factor | 1.1974 |
| Shear stress with the Wahl factor | 317.62 MPa |
| Deflection under the load | 28.373 mm |
Open this example in the calculator and change any input.
Formula
\(k = \frac{G d^4}{8 D^3 n_a}, \quad C = \frac{D}{d}\)
\(K_W = \frac{4C - 1}{4C - 4} + \frac{0.615}{C}, \quad \tau = K_W \frac{8 F D}{\pi d^3}, \quad \delta = \frac{F}{k}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(d\) | Wire diameter | m |
| \(D\) | Mean coil diameter | m |
| \(n_a\) | Number of active coils | - |
| \(G\) | Shear modulus of the wire | Pa |
| \(F\) | Load | N |
| \(k\) | Spring rate | N/m |
| \(C\) | Spring index D/d | - |
| \(K_W\) | Wahl stress factor | - |
| \(\tau\) | Shear stress with the Wahl factor | Pa |
| \(\delta\) | Deflection under the load | m |
Method and standards
The rate of a close-coiled helical spring follows from the torsion of the wire; Wahl's factor corrects the nominal torsional stress for curvature and direct shear.
Where it is used
- Designing and checking valve, relief and machine springs.
- Selecting a stock spring.
- Checking a spring after a load change.
Common mistakes
- Counting all coils as active (closed ends are not).
- Using outside diameter instead of mean diameter.
- Comparing the stress with tensile instead of torsional strength.
Assumptions and limits
- Round wire, close-coiled; static load.
- Fatigue and buckling not checked; the stress is not compared with an allowable, and the solid height (coil clash, which limits the deflection) is not checked.
References
- A.M. Wahl
- Mechanical Springs (1963)
- Shigley's Mechanical Engineering Design
- ch. 10
Questions and answers
What is the rate of a 6 mm wire spring, 45 mm mean diameter, 8 active coils?
In steel (G 79.3 GPa), 17.6 N/mm; 500 N compresses it 28 mm.
What stress does that load cause?
With spring index 7.5 the Wahl factor is 1.197 and the corrected shear stress 318 MPa.
Why the Wahl factor?
It adds the direct shear and the extra stress on the inside of the coil from curvature; springs fail there first.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.