Worked example
Example: 1,000 rpm, 20°, θ 30°. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Input speed | 1,000.0 rpm |
| Angle between shafts | 20.000 ° |
| Input shaft position, from the driving yoke perpendicular to the plane of the shafts | 30.000 ° |
Applying the formula below gives:
| Result | Value |
|---|---|
| Output speed at θ | 968.00 rpm |
| Maximum output speed | 1,064.2 rpm |
| Minimum output speed | 939.69 rpm |
| Total fluctuation | 12.449 % |
Open this example in the calculator and change any input.
Formula
\(\frac{\omega_2}{\omega_1} = \frac{\cos\alpha}{1 - \sin^2\theta\sin^2\alpha}, \quad N_{2,max} = \frac{N_1}{\cos\alpha}, \quad N_{2,min} = N_1\cos\alpha\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(N_1\) | Input speed | 1/s |
| \(\alpha\) | Angle between shafts | rad |
| \(\theta\) | Input shaft position, from the driving yoke perpendicular to the plane of the shafts | rad |
| \(N_2\) | Output speed at θ | 1/s |
| \(N_{2,max}\) | Maximum output speed | 1/s |
| \(N_{2,min}\) | Minimum output speed | 1/s |
| \(\Delta N/N_1\) | Total fluctuation | - |
Method and standards
Hooke's joint kinematics.
Where it is used
- Drive shafts and cardan shafts.
- Mill and conveyor drives.
Common mistakes
- Large angles with a single joint.
- Out-of-phase yokes on a double joint.
Assumptions and limits
- Rigid joint.
- θ is measured from the position where the driving yoke is perpendicular to the plane containing both shafts: the output is slowest there (θ = 0°, 180°) and fastest at θ = 90°, 270°.
References
- Rattan
- Theory of Machines
- 4th ed. (McGraw-Hill, 2014); Bhandari
- Design of Machine Elements
- 4th ed. (McGraw-Hill, 2017) (Hooke's joint: ω₂/ω₁ = cos α/(1 − sin²θ sin²α))
Questions and answers
Why does the output speed vary?
A single universal joint at an angle is not a constant-velocity joint: output speed swings twice per revolution.
How big is the swing?
At 20° the output varies between 0.94 and 1.06 times the input, about 12 %.
What do the defaults represent?
A shaft at 1,000 rpm through a joint angled at 20°.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.