Worked example
Example: 200 N·m, 400 mm wrench, 60 mm crowfoot. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Torque wanted at the fastener | 200.00 N·m |
| Wrench length (hand grip to square drive) | 400.00 mm |
| Extension length in line (negative if folded back) | 60.000 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Setting on the wrench T_a L/(L + E) | 173.91 N·m |
| Correction ratio | 0.86957 |
Open this example in the calculator and change any input.
Formula
\(T_w = T_a\, \frac{L}{L + E}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(T_a\) | Torque wanted at the fastener | N·m |
| \(L\) | Wrench length (hand grip to square drive) | m |
| \(E\) | Extension length in line (negative if folded back) | m |
| \(T_w\) | Setting on the wrench T_a L/(L + E) | N·m |
| \(L/(L + E)\) | Correction ratio | - |
Method and standards
Moments about the fastener.
Where it is used
- Flange and engine bolting.
- Maintenance.
Common mistakes
- Measuring L from the wrong point.
- Correcting for a 90° extension.
Assumptions and limits
Only in-line (E positive) or folded-back (E negative) extensions are covered. For an extension at an angle α to the wrench, use the effective extension E cos α in place of E; at 90° no correction is needed.
Extension in line with the wrench.
References
- Moment balance about the fastener
Questions and answers
200 N·m wanted with a 400 mm wrench and a 60 mm crowfoot?
Set the wrench to 173.9 N·m.
At 90°?
No correction: the extension adds no lever arm.
Folded back?
Enter the extension as negative; the setting rises.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.