Worked example
Example: Two-start, 12.6 mm pitch, 50 mm worm, f 0.05. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Number of worm starts | 2.0000 - |
| Axial pitch of the worm | 12.600 mm |
| Worm pitch diameter | 50.000 mm |
| Normal pressure angle | 20.000 ° |
| Coefficient of friction | 0.050000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Lead z_w p_x | 25.200 mm |
| Lead angle | 9.1142 ° |
| Efficiency, worm driving | 74.453 % |
| Self-locking (1 = yes, 0 = no) | 0 |
Open this example in the calculator and change any input.
Formula
\(\tan\lambda = \frac{z_w p_x}{\pi d_w}, \quad \eta = \frac{\cos\phi_n - f\tan\lambda}{\cos\phi_n + f\cot\lambda}, \quad \text{self-locking if } f \ge \cos\phi_n \tan\lambda\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(z_w\) | Number of worm starts | - |
| \(p_x\) | Axial pitch of the worm | m |
| \(d_w\) | Worm pitch diameter | m |
| \(\phi_n\) | Normal pressure angle | rad |
| \(f\) | Coefficient of friction | - |
| \(L\) | Lead z_w p_x | m |
| \(\lambda\) | Lead angle | rad |
| \(\eta\) | Efficiency, worm driving | - |
| \(\text{locks}\) | Self-locking (1 = yes, 0 = no) | - |
Method and standards
Force analysis of the worm thread.
Where it is used
- Gearbox selection.
- Hoists and turntables.
Common mistakes
- Relying on self-locking as a brake.
- Using static friction for running efficiency.
Assumptions and limits
- Worm driving; bearing losses excluded.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 13 (η = (cos φn − f tan λ)/(cos φn + f cot λ); self-locking f ≥ cos φn tan λ)
Questions and answers
A two-start worm, 12.6 mm pitch, 50 mm diameter, f 0.05?
Lead angle 9.11°, efficiency 74 %.
When does a worm lock?
When friction exceeds cos φ_n tan λ, typically single-start worms with small lead angles.
Why are worms inefficient?
The teeth slide rather than roll.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.