Worked example
Example: 50 kN, 8 mm lead, 46 mm mean, μ 0.12, 0.5 m handle. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Load lifted | 50.000 kN |
| Lead of the thread (pitch × starts) | 8.0000 mm |
| Mean thread diameter | 46.000 mm |
| Coefficient of friction of the thread | 0.12000 - |
| Handle length (radius of the effort) | 0.50000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Helix angle tan α = p/(π d_m) | 3.1686 ° |
| Torque to raise | 203.01 N·m |
| Effort at the handle | 0.40602 kN |
| Efficiency tan α / tan(α + φ) | 31.359 % |
| Torque to lower (negative = runs down by itself) | 73.847 N·m |
Open this example in the calculator and change any input.
Formula
\(\tan\alpha = \frac{p}{\pi d_m}, \quad T = W\frac{d_m}{2}\tan(\alpha + \phi), \quad \eta = \frac{\tan\alpha}{\tan(\alpha + \phi)}, \quad \tan\phi = \mu\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(W\) | Load lifted | N |
| \(p\) | Lead of the thread (pitch × starts) | m |
| \(d_m\) | Mean thread diameter | m |
| \(\mu\) | Coefficient of friction of the thread | - |
| \(R\) | Handle length (radius of the effort) | m |
| \(\alpha\) | Helix angle tan α = p/(π d_m) | rad |
| \(T\) | Torque to raise | N·m |
| \(P_e\) | Effort at the handle | N |
| \(\eta\) | Efficiency tan α / tan(α + φ) | - |
| \(T_L\) | Torque to lower (negative = runs down by itself) | N·m |
Method and standards
Unwrapped thread as an inclined plane.
Where it is used
- Jacks, vices and presses.
- Machine design examinations.
Common mistakes
- Pitch instead of lead for multi-start.
- Forgetting collar friction.
Assumptions and limits
- Square thread, no collar friction.
References
- Square-thread screw on an inclined plane (textbook; Shigley's Mechanical Engineering Design (Budynas and Nisbett), ch. 8)
Questions and answers
Effort to lift 50 kN with an 8 mm lead, 46 mm mean diameter, μ 0.12, 0.5 m handle?
Torque 203 N·m, effort 406 N.
Why is efficiency below 50 %?
Every self-locking screw has efficiency under 50 %.
What about collar friction?
Add it separately; see the power screw calculator.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.