FireCADCalc

Inclined Plane with Friction: Force to Push Up and Down

Force parallel to an inclined plane to push a load up, to lower it and to hold it, with friction, the angle of repose and the mechanical efficiency.

Inputs

Examples: 500 kg, 20°, μ 0.25100 kg, 35°, μ 0.4 (slides)2 t, 5°, μ 0.1

Results

The load slides down by itself: the slope is steeper than the angle of repose.

Force to push up the slope2.8289kN
Force to push down (negative: it slides by itself)-0.52513kN
Normal force4.6076kN
Angle of repose atan μ14.036°
Efficiency of raising59.281%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 500 kg, 20°, μ 0.25. The inputs, in the units selected above:

InputValue
Mass of the load500.00 kg
Slope angle20.000 °
Coefficient of friction0.25000 -

Applying the formula below gives:

ResultValue
Force to push up the slope2.8289 kN
Force to push down (negative: it slides by itself)-0.52513 kN
Normal force4.6076 kN
Angle of repose atan μ14.036 °
Efficiency of raising59.281 %

Open this example in the calculator and change any input.

Formula

\(F_{up} = W(\sin\theta + \mu\cos\theta), \quad F_{down} = W(\mu\cos\theta - \sin\theta), \quad \eta = \frac{\sin\theta}{\sin\theta + \mu\cos\theta}\)

Variables

Symbol Meaning SI unit
\(m\) Mass of the load kg
\(\theta\) Slope angle rad
\(\mu\) Coefficient of friction -
\(F_{up}\) Force to push up the slope N
\(F_{down}\) Force to push down (negative: it slides by itself) N
\(N\) Normal force N
\(\phi\) Angle of repose atan μ rad
\(\eta\) Efficiency of raising -

Method and standards

Equilibrium along the plane.

Where it is used

  • Ramps, chutes and skids.
  • Statics examinations.

Common mistakes

  • Static friction for moving loads.
  • Force not parallel to the plane.

Assumptions and limits

  • Dry (Coulomb) friction with one coefficient: use the static μ for holding and starting, the (lower) kinetic μ for steady sliding.

References

  • Textbook mechanics (resolution of forces on an inclined plane)

Questions and answers

500 kg up a 20° slope with μ 0.25?

2829 N up; efficiency 59 %.

When does it slide by itself?

Above the angle of repose, 14.0° for μ 0.25.

Is the force parallel to the slope?

Yes; a horizontal push needs more.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.