Worked example
Example: 1 kN dropped 50 mm onto 2 000 N/mm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Falling weight | 1.0000 kN |
| Height of fall | 50.000 mm |
| Stiffness of the member at the impact point | 2,000.0 N/mm |
| Stress under the weight applied statically | 10.000 MPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Static deflection W/k | 0.50000 mm |
| Impact factor 1 + √(1 + 2h/δ_st) | 15.177 |
| Dynamic deflection | 7.5887 mm |
| Dynamic stress | 151.77 MPa |
| Peak dynamic force | 15.177 kN |
Open this example in the calculator and change any input.
Formula
\(\delta_{st} = \frac{W}{k}, \quad n = 1 + \sqrt{1 + \frac{2h}{\delta_{st}}}, \quad \sigma_d = n\, \sigma_{st}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(W\) | Falling weight | N |
| \(h\) | Height of fall | m |
| \(k\) | Stiffness of the member at the impact point | N/m |
| \(\sigma_{st}\) | Stress under the weight applied statically | Pa |
| \(\delta_{st}\) | Static deflection W/k | m |
| \(n\) | Impact factor 1 + √(1 + 2h/δ_st) | - |
| \(\delta_d\) | Dynamic deflection | m |
| \(\sigma_d\) | Dynamic stress | Pa |
| \(F_d\) | Peak dynamic force | N |
Method and standards
Energy balance on a linear spring.
Where it is used
- Lifting gear and buffers.
- Strength of materials examinations.
Common mistakes
- Using the static stress for drops.
- Ignoring stiff supports.
Assumptions and limits
- Elastic member, no mass.
- σ_st is your static stress under W (it is not computed from W); the dynamic stress is not compared with yield or an allowable, and a large impact factor is flagged.
References
- Energy balance W(h + δ) = ½ k δ² (Timoshenko, Strength of Materials)
Questions and answers
1 kN dropped 50 mm onto a member of 2000 N/mm?
Static deflection 0.5 mm; impact factor 15.2: 15.2 times the static stress.
And a suddenly applied load?
Twice the static value.
How to soften an impact?
Lower stiffness (a buffer or spring) raises the static deflection and lowers the factor.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.