FireCADCalc

Slope and Gradient Converter (%, Degrees, 1 in n)

Convert a slope given by rise and run into percent grade, angle in degrees, ratio 1 in n and slope length, for roads, drains, ramps, roofs and pipelines.

Inputs

Examples: 1 in 50 drain fallRamp rising 0.6 m over 7.2 m45° slopeLevel surface

Results

A 100 % grade is 45°, not vertical. Drainage falls are often written 1 in n (run per unit of fall).

Grade (rise / run)2.0000%
Angle1.1458°
1 in n (run per unit rise)50.000
Length along the slope50.010m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 1 in 50 drain fall. The inputs, in the units selected above:

InputValue
Rise (vertical)1.0000 m
Run (horizontal distance)50.000 m

Applying the formula below gives:

ResultValue
Grade (rise / run)2.0000 %
Angle1.1458 °
1 in n (run per unit rise)50.000
Length along the slope50.010 m

Open this example in the calculator and change any input.

Formula

\(G = \frac{\Delta z}{L_h}, \quad \theta = \arctan G, \quad n = \frac{L_h}{\Delta z}, \quad L_s = \sqrt{\Delta z^2 + L_h^2}\)

Variables

Symbol Meaning SI unit
\(\Delta z\) Rise (vertical) m
\(L_h\) Run (horizontal distance) m
\(G\) Grade (rise / run) -
\(\theta\) Angle rad
\(n\) 1 in n (run per unit rise) -
\(L_s\) Length along the slope m

Method and standards

Right-angled triangle relations.

Where it is used

  • Drain and sewer falls.
  • Ramps and roads.
  • Pipe slopes for condensate return.

Common mistakes

  • Confusing % with degrees.
  • Using slope length as run.

Assumptions and limits

  • Straight slope, given by rise and run. To convert from a grade or an angle, enter a run of 100 and the grade in per cent as the rise, or a run of 1 and tan θ as the rise.
  • A level surface (zero rise) gives zero grade and angle; 1 in n is then not defined and not shown.

References

  • Trigonometry of a slope

Questions and answers

What is a 1 in 50 fall?

2 % or 1.15°.

Is 100 % vertical?

No: 100 % is 45°.

What slope is a 0.6 m rise over 7.2 m?

8.3 %, 1 in 12, 4.76°.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.