FireCADCalc

Normal Distribution: Probability Below, Above and Between

Probability that a normally distributed quantity is below a value, above it or between two values, from the mean and standard deviation, with the z-scores.

Inputs

Examples: Mean 30, SD 2.5Standard normal ±1.96

Results

z-score of x₁-1.6000
Probability below x₁5.4799%
Probability above x₂5.4799%
Probability between89.040%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Mean 30, SD 2.5. The inputs, in the units selected above:

InputValue
Mean30.000 -
Standard deviation2.5000 -
Lower value26.000 -
Upper value34.000 -

Applying the formula below gives:

ResultValue
z-score of x₁-1.6000
Probability below x₁5.4799 %
Probability above x₂5.4799 %
Probability between89.040 %

Open this example in the calculator and change any input.

Formula

\(P(X < x) = \frac{1}{2}\left[1 + \operatorname{erf}\left(\frac{x - \mu}{\sigma\sqrt2}\right)\right]\)

Variables

Symbol Meaning SI unit
\(\mu\) Mean -
\(\sigma\) Standard deviation -
\(x_1\) Lower value -
\(x_2\) Upper value -
\(z_1\) z-score of x₁ -
\(P(X < x_1)\) Probability below x₁ -
\(P(X > x_2)\) Probability above x₂ -
\(P(x_1 < X < x_2)\) Probability between -

Method and standards

Normal distribution.

Where it is used

  • Quality control limits.
  • Strength acceptance checks.

Common mistakes

  • Using sample SD of very few results.
  • Assuming normality without checking.

Assumptions and limits

  • Normal distribution. Tail probabilities are computed from the complementary error function, so very small tails (parts per million) keep their precision.

References

  • Normal distribution Φ(z) = ½[1 + erf(z/√2)]

Questions and answers

Mean 30, SD 2.5: below 26?

5.48 %; between 26 and 34 89.0 %.

Characteristic strength?

The value with 5 % below is the mean − 1.645 SD.

Is my data normal?

Check a histogram; strengths and errors often are.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.