Worked example
Example: Three blocks. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Fatigue strength coefficient | 900.00 MPa |
| Fatigue strength exponent | -0.090000 - |
| Block 1: stress amplitude | 300.00 MPa |
| Block 1: cycles applied | 20,000 - |
| Block 2: stress amplitude | 250.00 MPa |
| Block 2: cycles applied | 100,000 - |
| Block 3: stress amplitude | 200.00 MPa |
| Block 3: cycles applied | 500,000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Block 1: cycles to failure | 100,073 |
| Block 2: cycles to failure | 758,768 |
| Block 3: cycles to failure | 9,054,966 |
| Miner damage sum | 0.38686 |
| Repeats of the block sequence left (1/D − 1) | 1.5849 |
Open this example in the calculator and change any input.
Formula
\(N_f = \frac{1}{2}\left(\frac{\sigma_a}{\sigma_f'}\right)^{1/b}, \quad D = \sum\frac{n_i}{N_{f,i}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\sigma_f'\) | Fatigue strength coefficient | Pa |
| \(b\) | Fatigue strength exponent | - |
| \(\sigma_{a1}\) | Block 1: stress amplitude | Pa |
| \(n_{1}\) | Block 1: cycles applied | - |
| \(\sigma_{a2}\) | Block 2: stress amplitude | Pa |
| \(n_{2}\) | Block 2: cycles applied | - |
| \(\sigma_{a3}\) | Block 3: stress amplitude | Pa |
| \(n_{3}\) | Block 3: cycles applied | - |
| \(N_{f1}\) | Block 1: cycles to failure | - |
| \(N_{f2}\) | Block 2: cycles to failure | - |
| \(N_{f3}\) | Block 3: cycles to failure | - |
| \(D\) | Miner damage sum | - |
| \(R\) | Repeats of the block sequence left (1/D − 1) | - |
Method and standards
Basquin and Miner.
Where it is used
- Fatigue checks of rotating and vibrating parts.
- Remaining life estimates.
Common mistakes
- Cycles vs reversals (2N).
- Ignoring mean stress and notches.
Assumptions and limits
- High-cycle, fully reversed.
- No endurance limit: every amplitude above zero adds damage, which is conservative for amplitudes below the endurance limit. A block of zero amplitude adds none and its cycles to failure are not shown.
- No mean-stress correction: correct the amplitudes first.
References
- Basquin (1910) σ_a = σ_f'(2N_f)^b; Palmgren–Miner linear damage D = Σ n_i/N_i
Questions and answers
Blocks at 300, 250 and 200 MPa with the default constants?
Damage about 0.39.
What do the constants mean?
σ_f' is the stress for one reversal; b sets the slope of the S-N line.
Mean stress?
Correct the amplitude first (Goodman, Gerber or Morrow).
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.