FireCADCalc

Alloy Density from Composition (Rule of Mixtures)

Approximate density of an alloy or mixture from the mass fractions and densities of up to four constituents, by volume additivity.

Inputs

Examples: 304-like stainlessBrass 65/35

Constituent 1

Constituent 2

Constituent 3

Constituent 4

Results

Volume additivity is an approximation; measured alloy densities can differ by a per cent or so.

Alloy density7,800.1kg/m³
Specific volume0.12820L/kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 304-like stainless. The inputs, in the units selected above:

InputValue
Constituent 1: mass fraction70.000 %
Constituent 1: density7,874.0 kg/m³
Constituent 2: mass fraction19.000 %
Constituent 2: density7,190.0 kg/m³
Constituent 3: mass fraction9.0000 %
Constituent 3: density8,908.0 kg/m³
Constituent 4: mass fraction2.0000 %
Constituent 4: density7,210.0 kg/m³

Applying the formula below gives:

ResultValue
Alloy density7,800.1 kg/m³
Specific volume0.12820 L/kg

Open this example in the calculator and change any input.

Formula

\(\frac{1}{\rho} = \sum_i \frac{w_i}{\rho_i}\)

Variables

Symbol Meaning SI unit
\(w_{1}\) Constituent 1: mass fraction -
\(\rho_{1}\) Constituent 1: density kg/m³
\(w_{2}\) Constituent 2: mass fraction -
\(\rho_{2}\) Constituent 2: density kg/m³
\(w_{3}\) Constituent 3: mass fraction -
\(\rho_{3}\) Constituent 3: density kg/m³
\(w_{4}\) Constituent 4: mass fraction -
\(\rho_{4}\) Constituent 4: density kg/m³
\(\rho\) Alloy density kg/m³
\(v\) Specific volume m³/kg

Method and standards

Volume additivity.

Where it is used

  • Weight of special alloy parts.
  • Powder and casting estimates.

Common mistakes

  • Arithmetic mean of densities.
  • Atomic instead of mass fractions.

Assumptions and limits

  • Ideal mixing.
  • Mass fractions that do not add to 100 % are normalised, with a note.

References

  • Ideal volume additivity 1/ρ = Σ w_i/ρ_i

Questions and answers

70 Fe, 19 Cr, 9 Ni, 2 Mn (304-like)?

About 7800 kg/m³ (304 is quoted at about 7900–8000).

Why not average the densities?

Masses add, volumes add: the right average is harmonic.

Porous parts?

Multiply by the relative density.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.