FireCADCalc

Powder Metallurgy Compact: Green Density and Porosity

Green density, relative density and porosity of a pressed powder compact from its mass and dimensions and the full (theoretical) density.

Inputs

Examples: Iron powder compactAlumina pellet

Results

Sintering raises the density further and shrinks the part.

Green density6,576.5kg/m³
Relative density83.564%
Porosity16.436%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Iron powder compact. The inputs, in the units selected above:

InputValue
Compact mass21.500 g
Compact diameter15.000 mm
Compact height18.500 mm
Full (theoretical) density7,870.0 kg/m³

Applying the formula below gives:

ResultValue
Green density6,576.5 kg/m³
Relative density83.564 %
Porosity16.436 %

Open this example in the calculator and change any input.

Formula

\(\rho_g = \frac{m}{\pi D^2 H/4}, \quad \varepsilon = 1 - \frac{\rho_g}{\rho_t}\)

Variables

Symbol Meaning SI unit
\(m\) Compact mass kg
\(D\) Compact diameter m
\(H\) Compact height m
\(\rho_t\) Full (theoretical) density kg/m³
\(\rho_g\) Green density kg/m³
\(\rho_g/\rho_t\) Relative density -
\(\varepsilon\) Porosity -

Method and standards

Definitions.

Where it is used

  • PM parts and bushes.
  • Ceramic and refractory pressing.

Common mistakes

  • Mass in g with volume in m³.
  • Hollow parts as solid cylinders.

Assumptions and limits

  • Solid cylinder.

References

  • Density = mass/volume of a cylinder; porosity = 1 − ρ/ρ_t

Questions and answers

21.5 g in a 15 mm × 18.5 mm cylinder of iron powder?

Green density about 6576 kg/m³: 84 % of full.

Typical values?

Pressed iron parts are often 85–90 % dense.

Why measure?

Density controls strength and sintering shrinkage.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.