FireCADCalc

Yield Strength from Grain Size (Hall–Petch)

Yield strength of a metal from its grain size by the Hall–Petch relation with your friction stress and locking constant, and the grain size for a target strength.

Inputs

Examples: Mild steel constants, 20 µmCopper-like

From data for the alloy.

Results

Holds down to about 10–20 nm; constants depend on the alloy and its condition.

Yield strength235.47MPa
Grain size for the target10.352µm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Mild steel constants, 20 µm. The inputs, in the units selected above:

InputValue
Friction stress70.000 MPa
Locking parameter (MPa·m^½)0.74000 -
Mean grain diameter20.000 µm
Target yield strength300.00 MPa

Applying the formula below gives:

ResultValue
Yield strength235.47 MPa
Grain size for the target10.352 µm

Open this example in the calculator and change any input.

Formula

\(\sigma_y = \sigma_0 + \frac{k_y}{\sqrt d}, \quad d_t = \left(\frac{k_y}{\sigma_t - \sigma_0}\right)^2\)

Variables

Symbol Meaning SI unit
\(\sigma_0\) Friction stress Pa
\(k_y\) Locking parameter (MPa·m^½) -
\(d\) Mean grain diameter m
\(\sigma_t\) Target yield strength Pa
\(\sigma_y\) Yield strength Pa
\(d_t\) Grain size for the target m

Method and standards

Hall–Petch.

Where it is used

  • Steel selection and weld HAZ discussion.
  • Teaching and examinations.

Common mistakes

  • d in mm with k in MPa·m^½.
  • Using one steel's constants for another.

Assumptions and limits

  • Room temperature, single-phase.
  • When the target is at or below σ₀ any grain size reaches it, and the grain size for the target is not shown.

References

  • Hall (1951) and Petch (1953): σ_y = σ₀ + k_y d^(−½)

Questions and answers

Mild steel constants, 20 µm grains?

About 235 MPa.

Grain size for 300 MPa?

About 10.4 µm.

Why do fine grains strengthen?

Grain boundaries block dislocations.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.