FireCADCalc

Thermal Conductivity of a Particulate Composite

Effective thermal conductivity of a matrix with dispersed particles by the Maxwell–Eucken equation, with the parallel and series bounds.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliserPulp and paper

Inputs

Examples: Polymer with 30 % ceramic fillerPorous refractory: 40 % air pores in alumina

Results

Maxwell–Eucken for spheres not touching each other (dilute to moderate loading). Above roughly 30–40 % the particles form conducting paths and conductivity rises faster (percolation).

Maxwell–Eucken conductivity0.44995W/(m·K)
Parallel (upper) bound9.1400W/(m·K)
Series (lower) bound0.28490W/(m·K)

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Polymer with 30 % ceramic filler. The inputs, in the units selected above:

InputValue
Matrix (continuous phase) conductivity0.20000 W/(m·K)
Dispersed particle conductivity30.000 W/(m·K)
Particle volume fraction30.000 %

Applying the formula below gives:

ResultValue
Maxwell–Eucken conductivity0.44995 W/(m·K)
Parallel (upper) bound9.1400 W/(m·K)
Series (lower) bound0.28490 W/(m·K)

Open this example in the calculator and change any input.

Formula

\(k = k_m\frac{k_d + 2k_m + 2\phi(k_d - k_m)}{k_d + 2k_m - \phi(k_d - k_m)}\)

Variables

Symbol Meaning SI unit
\(k_m\) Matrix (continuous phase) conductivity W/(m·K)
\(k_d\) Dispersed particle conductivity W/(m·K)
\(\phi\) Particle volume fraction -
\(k_{ME}\) Maxwell–Eucken conductivity W/(m·K)
\(k_\parallel\) Parallel (upper) bound W/(m·K)
\(k_\perp\) Series (lower) bound W/(m·K)

Method and standards

Maxwell–Eucken.

Where it is used

  • Thermal interface materials and filled polymers.
  • Porous refractories and insulation.

Common mistakes

  • Using it above percolation.
  • Mixing mass and volume fractions.

Assumptions and limits

  • Spherical, non-touching particles.

References

  • Maxwell (1873) / Eucken (1940) equation for dispersed spheres; Wiener parallel and series bounds

Questions and answers

Why is the result close to the matrix value?

Separated particles are surrounded by matrix, so heat must still cross the poorly conducting matrix.

Can it be used for porous materials?

Yes: treat pores as the dispersed phase with gas conductivity (insulating refractories, foams).

What do the defaults represent?

A polymer filled with 30 % by volume of a ceramic powder.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.