Worked example
Example: Edge crack, steel. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Applied stress | 200.00 MPa |
| Geometry factor | 1.1200 - |
| Fracture toughness (MPa·m^½) | 50.000 - |
| Crack size (depth or half-length) | 5.0000 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Stress intensity factor (MPa·m^½) | 28.074 |
| Critical crack size | 15.860 mm |
| Failure stress for the crack | 356.20 MPa |
Open this example in the calculator and change any input.
Formula
\(K_I = Y\sigma\sqrt{\pi a}, \quad a_c = \frac{1}{\pi}\left(\frac{K_{Ic}}{Y\sigma}\right)^2\)
Variables
| Symbol | Meaning | SI unit | ||
|---|---|---|---|---|
| \(\sigma\) | Applied stress | Pa | ||
| \(Y\) | Geometry factor | - | ||
| \(K_{Ic}\) | Fracture toughness (MPa·m½) | - | ||
| \(a\) | Crack size (depth or half-length) | m | ||
| \(K_I\) | Stress intensity factor (MPa·m½) | - | ||
| \(a_c\) | Critical crack size | m | ||
| \(\sigma_f\) | Failure stress for the crack | Pa |
Method and standards
LEFM.
Where it is used
- Inspection acceptance and fitness for service screening.
- Examinations.
Common mistakes
- Full crack length instead of half for centre cracks.
- Toughness at the wrong temperature.
Assumptions and limits
- Small-scale yielding: the failure stress must be well below the yield strength, which is not an input here.
- With no crack (a = 0) the failure stress is not shown.
- K_Ic and K_I are entered and shown in MPa·m^½ as their labels say; the unit lists do not convert them.
References
- K_I = Yσ√(πa); fracture when K_I = K_Ic (Irwin; linear-elastic fracture mechanics)
Questions and answers
200 MPa, edge crack, K_Ic 50 MPa·m^½?
Critical depth about 15.9 mm.
A 5 mm crack?
K about 28.1 MPa·m^½, below toughness.
Why low temperature matters?
Ferritic steel toughness drops sharply below its transition temperature.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.