Worked example
Example: 8 kN pads at 120 mm, 10 kg·m² from 1,000 rpm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Clamping force per pad | 8.0000 kN |
| Pad friction coefficient | 0.35000 - |
| Effective radius of the pads | 120.00 mm |
| Friction faces | 2.0000 - |
| Rotating inertia being stopped | 10.000 kg·m² |
| Initial speed | 1,000.0 rpm |
| Disc mass | 8.0000 kg |
| Disc specific heat | 0.46000 kJ/(kg·K) |
Applying the formula below gives:
| Result | Value |
|---|---|
| Braking torque | 672.00 N·m |
| Stopping time | 1.5583 s |
| Energy absorbed | 54.831 kJ |
| Disc temperature rise (all heat to the disc) | 14.900 K |
Open this example in the calculator and change any input.
Formula
\(T = \mu Fr_en_f, \quad t_s = \frac{I\omega}{T}, \quad E = \tfrac12I\omega^2, \quad \Delta T = \frac{E}{m_dc_d}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(F\) | Clamping force per pad | N |
| \(\mu\) | Pad friction coefficient | - |
| \(r_e\) | Effective radius of the pads | m |
| \(n_f\) | Friction faces | - |
| \(I\) | Rotating inertia being stopped | kg·m² |
| \(N\) | Initial speed | 1/s |
| \(m_d\) | Disc mass | kg |
| \(c_d\) | Disc specific heat | J/(kg·K) |
| \(T\) | Braking torque | N·m |
| \(t_s\) | Stopping time | s |
| \(E\) | Energy absorbed | J |
| \(\Delta T\) | Disc temperature rise (all heat to the disc) | K |
Method and standards
Friction torque and energy balance.
Where it is used
- Conveyor, crane and machine brakes.
- Emergency stop checks.
Common mistakes
- Counting one face for a two-sided disc.
- Ignoring repeated-stop heating.
Assumptions and limits
- Constant torque; adiabatic stop.
- The stopping time uses the brake torque on the inertia alone: a load torque that also resists (or drives) the shaft during the stop shortens (or lengthens) it.
References
- Budynas and Nisbett
- Shigley's Mechanical Engineering Design
- 10th ed. (McGraw-Hill, 2015)
- ch. 16 (disc brakes; energy considerations)
Questions and answers
What is the effective radius?
Roughly the mean radius of the pad; for uniform wear it is (r_o + r_i)/2.
Why check temperature?
Pad friction falls (fade) and discs crack if a stop dumps too much energy into too little steel.
What do the defaults represent?
Two-faced caliper, 8 kN per pad at 120 mm radius, stopping 10 kg·m² from 1,000 rpm.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.