Worked example
Example: 50 mm solid shaft, 100 mm hub, 40 µm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Diametral interference | 40.000 µm |
| Nominal fit diameter | 50.000 mm |
| Hub outside diameter | 100.00 mm |
| Shaft bore (0 for solid) | 0 mm |
| Modulus (hub and shaft) | 207.00 GPa |
| Poisson's ratio | 0.30000 - |
| Length of the fit | 60.000 mm |
| Coefficient of friction | 0.12000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Contact pressure | 62.100 MPa |
| Hoop stress at the hub bore | 103.50 MPa |
| Hoop stress at the shaft surface | -62.100 MPa |
| Torque the fit can carry π f p d² l / 2 | 1,755.8 N·m |
| Axial press-in force π f p d l | 70.233 kN |
Open this example in the calculator and change any input.
Formula
\(p = \frac{\delta}{d\left[\dfrac{1}{E}\left(\dfrac{d_o^2 + d^2}{d_o^2 - d^2} + \nu\right) + \dfrac{1}{E}\left(\dfrac{d^2 + d_i^2}{d^2 - d_i^2} - \nu\right)\right]}\)
\(T = \frac{\pi f p d^2 l}{2}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\delta\) | Diametral interference | m |
| \(d\) | Nominal fit diameter | m |
| \(d_o\) | Hub outside diameter | m |
| \(d_i\) | Shaft bore (0 for solid) | m |
| \(E\) | Modulus (hub and shaft) | Pa |
| \(\nu\) | Poisson's ratio | - |
| \(l\) | Length of the fit | m |
| \(f\) | Coefficient of friction | - |
| \(p\) | Contact pressure | Pa |
| \(\sigma_{t,o}\) | Hoop stress at the hub bore | Pa |
| \(\sigma_{t,i}\) | Hoop stress at the shaft surface | Pa |
| \(T\) | Torque the fit can carry π f p d² l / 2 | N·m |
| \(F_a\) | Axial press-in force π f p d l | N |
Method and standards
Lamé thick-cylinder solution at the common surface.
Where it is used
- Gears, couplings and bearings on shafts.
- Machine design examinations.
Common mistakes
- Radial instead of diametral interference.
- Mixed materials with one modulus.
Assumptions and limits
- Same material, elastic, long hub.
- No yield check of the hub bore (combined hoop and radial stress), no allowance for surface smoothing (loss of interference on pressing), and hub and shaft of different materials are not supported.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 2–3 (press and shrink fits, Lamé thick cylinders)
Questions and answers
A 50 mm solid steel shaft in a 100 mm hub with 40 µm interference?
Pressure about 62 MPa.
What torque can it carry?
π f p d² l / 2 with the friction coefficient of the surfaces.
Which interference?
The actual interference after machining tolerances and surface smoothing.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.