Worked example
Example: Open: 400 and 160 mm, 800 mm centres, 1450 rpm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Large pulley diameter (pitch) | 400.00 mm |
| Small pulley diameter (pitch) | 160.00 mm |
| Centre distance | 800.00 mm |
| Belt drive | Open belt |
| Speed of the small (driving) pulley | 1,450.0 rpm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Belt pitch length | 2,497.6 mm |
| Wrap angle on the small pulley | 162.75 ° |
| Belt speed | 12.147 m/s |
| Speed of the large pulley (no slip) | 580.00 rpm |
Open this example in the calculator and change any input.
Formula
\(L = 2C + \frac{\pi (D + d)}{2} + \frac{(D \mp d)^2}{4C} \qquad \theta = \pi \mp 2\arcsin\frac{D \mp d}{2C} \qquad v = \pi d\,n_1 \qquad n_2 = n_1\frac{d}{D}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | large pulley pitch diameter | m |
| \(d\) | small pulley pitch diameter | m |
| \(C\) | centre distance | m |
| \(\text{drive}\) | open or crossed | – |
| \(n_1\) | small pulley speed | rev/s |
| \(L\) | belt pitch length | m |
| \(\theta\) | wrap angle on small pulley | rad |
| \(v\) | belt speed | m/s |
| \(n_2\) | large pulley speed | rev/s |
Method and standards
Exact geometry of the open belt with the usual series approximation for length (upper signs open, lower signs crossed for the bracketed terms).
Where it is used
- Fan and pump belt drives.
- Changing fan speed by pulley.
- Replacement belt selection.
Common mistakes
- Using outside diameters.
- Forgetting slip (1–2 %).
- Too short a centre distance.
Assumptions and limits
- Rigid inextensible belt; no slip.
- The length uses the series approximation; when it differs from the exact L = 2C cos α + π(D+d)/2 + α(D−d) (open belt) by more than 0.5 % the exact length is given in a note.
References
- Belt drive geometry
Questions and answers
What belt fits 400 and 160 mm pulleys at 800 mm centres?
2.498 m pitch length; wrap on the small pulley 162.7°; at 1450 rpm the belt runs at 12.2 m/s and the large pulley turns at 580 rpm.
Why check wrap angle?
Below about 120° V-belts slip; increase the centre distance or add an idler.
Pitch or outside diameter?
Pitch diameters; take them from the pulley catalogue.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.