Worked example
Example: 15 kW at 1 440 rpm, 80 mm spur pinion. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Power transmitted | 15.000 kW |
| Speed of the gear | 1,440.0 rpm |
| Pitch diameter | 80.000 mm |
| Normal pressure angle | 20.000 ° |
| Helix angle (0 for spur gears) | 0 ° |
Applying the formula below gives:
| Result | Value |
|---|---|
| Torque on the gear | 99.472 N·m |
| Tangential force | 2.4868 kN |
| Radial (separating) force | 0.90512 kN |
| Axial (thrust) force | 0 kN |
| Total tooth force | 2.6464 kN |
| Pitch line velocity | 6.0319 m/s |
Open this example in the calculator and change any input.
Formula
\(W_t = \frac{2T}{d}, \quad W_r = W_t\, \frac{\tan\phi_n}{\cos\psi}, \quad W_a = W_t \tan\psi\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(P\) | Power transmitted | W |
| \(n\) | Speed of the gear | 1/s |
| \(d\) | Pitch diameter | m |
| \(\phi_n\) | Normal pressure angle | rad |
| \(\psi\) | Helix angle (0 for spur gears) | rad |
| \(T\) | Torque on the gear | N·m |
| \(W_t\) | Tangential force | N |
| \(W_r\) | Radial (separating) force | N |
| \(W_a\) | Axial (thrust) force | N |
| \(W\) | Total tooth force | N |
| \(v\) | Pitch line velocity | m/s |
Method and standards
Resolution of the normal tooth force.
Where it is used
- Bearing and shaft design.
- Gearbox checks.
Common mistakes
- Using tip diameter.
- Forgetting axial thrust of helical gears.
Assumptions and limits
- Friction neglected.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 13 (W_t = 2T/d, W_r = W_t tan φ_n / cos ψ, W_a = W_t tan ψ)
Questions and answers
What forces does a 80 mm pinion carry at 15 kW and 1440 rpm?
Torque 99.5 N·m, tangential 2487 N, radial 905 N.
What does a helix add?
An axial thrust W_t tan ψ that the bearings must take.
Which diameter?
The pitch diameter of the gear whose speed is entered.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.