Worked example
Example: 20 and 30 N/mm in parallel, 1 kN. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Rate of spring 1 | 20.000 N/mm |
| Rate of spring 2 | 30.000 N/mm |
| Rate of spring 3 (0 if there is no third spring) | 0 N/mm |
| Arrangement | Parallel (side by side) |
| Load | 1.0000 kN |
Applying the formula below gives:
| Result | Value |
|---|---|
| Equivalent rate | 50.000 N/mm |
| Deflection under the load | 20.000 mm |
| Load on spring 1 | 0.40000 kN |
Open this example in the calculator and change any input.
Formula
\(k_{par} = \sum k_i, \quad \frac{1}{k_{ser}} = \sum \frac{1}{k_i}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(k_1\) | Rate of spring 1 | N/m |
| \(k_2\) | Rate of spring 2 | N/m |
| \(k_3\) | Rate of spring 3 (0 if there is no third spring) | N/m |
| \(\text{arr}\) | Arrangement | - |
| \(F\) | Load | N |
| \(k\) | Equivalent rate | N/m |
| \(\delta\) | Deflection under the load | m |
| \(F_1\) | Load on spring 1 | N |
Method and standards
Equal deflection (parallel) or equal force (series).
Where it is used
- Spring packs and mounts.
- Vibration isolation.
Common mistakes
- Swapping the rules.
- Ignoring preload differences.
Assumptions and limits
- Linear springs; k₃ = 0 means there is no third spring, in either arrangement.
References
- Hooke's law for combined springs
Questions and answers
20 and 30 N/mm in parallel?
50 N/mm; 1 kN deflects them 20 mm.
And in series?
12 N/mm: the softer spring dominates.
Where is it used?
Nested valve springs, mounts and supports in series with a frame.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.