FireCADCalc

Rack and Pinion: Linear Speed, Force and Travel

Linear speed, force and travel per revolution of a rack and pinion from the pinion pitch diameter (or module and teeth), the speed and torque.

Inputs

Examples: Module 3, 20 teeth, 60 rpm, 50 N·mModule 2, 30 teeth, 120 rpm, 20 N·mModule 6, 18 teeth, 15 rpm, 400 N·m

Results

Pitch diameter m z60.000mm
Travel per revolution π d188.50mm
Linear speed11.310m/min
Linear force 2T/d1.6667kN
Power314.16W

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Module 3, 20 teeth, 60 rpm, 50 N·m. The inputs, in the units selected above:

InputValue
Module3.0000 mm
Pinion teeth20.000 -
Pinion speed60.000 rpm
Pinion torque50.000 N·m

Applying the formula below gives:

ResultValue
Pitch diameter m z60.000 mm
Travel per revolution π d188.50 mm
Linear speed11.310 m/min
Linear force 2T/d1.6667 kN
Power314.16 W

Open this example in the calculator and change any input.

Formula

\(d = m z, \quad v = \pi d N, \quad F = \frac{2T}{d}\)

Variables

Symbol Meaning SI unit
\(m\) Module m
\(z\) Pinion teeth -
\(N\) Pinion speed 1/s
\(T\) Pinion torque N·m
\(d\) Pitch diameter m z m
\(s\) Travel per revolution π d m
\(v\) Linear speed m/s
\(F\) Linear force 2T/d N
\(P\) Power W

Method and standards

Pitch circle kinematics.

Where it is used

  • Gates, slides and steering.
  • Linear axis sizing.

Common mistakes

  • Using tip diameter.
  • rpm into the speed formula.

Assumptions and limits

  • No slip, friction neglected.

References

  • Rolling pitch circle on the rack pitch line

Questions and answers

Module 3, 20 teeth at 60 rpm and 50 N·m?

Pitch diameter 60 mm, travel 188.5 mm per turn, speed 11.31 m/min, force 1667 N.

Is the force friction-free?

Yes; allow for gear efficiency (typically 95 % or more).

Why module?

The rack's tooth pitch is π m.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.