Worked example
Example: Module 3, 20 teeth, 60 rpm, 50 N·m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Module | 3.0000 mm |
| Pinion teeth | 20.000 - |
| Pinion speed | 60.000 rpm |
| Pinion torque | 50.000 N·m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Pitch diameter m z | 60.000 mm |
| Travel per revolution π d | 188.50 mm |
| Linear speed | 11.310 m/min |
| Linear force 2T/d | 1.6667 kN |
| Power | 314.16 W |
Open this example in the calculator and change any input.
Formula
\(d = m z, \quad v = \pi d N, \quad F = \frac{2T}{d}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(m\) | Module | m |
| \(z\) | Pinion teeth | - |
| \(N\) | Pinion speed | 1/s |
| \(T\) | Pinion torque | N·m |
| \(d\) | Pitch diameter m z | m |
| \(s\) | Travel per revolution π d | m |
| \(v\) | Linear speed | m/s |
| \(F\) | Linear force 2T/d | N |
| \(P\) | Power | W |
Method and standards
Pitch circle kinematics.
Where it is used
- Gates, slides and steering.
- Linear axis sizing.
Common mistakes
- Using tip diameter.
- rpm into the speed formula.
Assumptions and limits
- No slip, friction neglected.
References
- Rolling pitch circle on the rack pitch line
Questions and answers
Module 3, 20 teeth at 60 rpm and 50 N·m?
Pitch diameter 60 mm, travel 188.5 mm per turn, speed 11.31 m/min, force 1667 N.
Is the force friction-free?
Yes; allow for gear efficiency (typically 95 % or more).
Why module?
The rack's tooth pitch is π m.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.