Worked example
Example: 4 kN, μ 0.3, 250/150 mm, single plate (2 faces). The inputs, in the units selected above:
| Input | Value |
|---|---|
| Axial clamping force | 4.0000 kN |
| Coefficient of friction | 0.30000 - |
| Outer radius of the friction face | 125.00 mm |
| Inner radius | 75.000 mm |
| Number of friction surfaces | 2.0000 - |
| Speed (for the power) | 1,500.0 rpm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Torque, uniform wear (worn clutch) | 240.00 N·m |
| Torque, uniform pressure (new clutch) | 245.00 N·m |
| Highest pressure (uniform wear, at the inner radius) | 169.77 kPa |
| Power at the speed (uniform wear) | 37.699 kW |
Open this example in the calculator and change any input.
Formula
\(T_w = n\, \mu F\, \frac{r_o + r_i}{2}, \quad T_p = n\, \mu F\, \frac{2}{3}\, \frac{r_o^3 - r_i^3}{r_o^2 - r_i^2}, \quad p_{max} = \frac{F}{2\pi r_i (r_o - r_i)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(F\) | Axial clamping force | N |
| \(\mu\) | Coefficient of friction | - |
| \(r_o\) | Outer radius of the friction face | m |
| \(r_i\) | Inner radius | m |
| \(n\) | Number of friction surfaces | - |
| \(N\) | Speed (for the power) | 1/s |
| \(T_w\) | Torque, uniform wear (worn clutch) | N·m |
| \(T_p\) | Torque, uniform pressure (new clutch) | N·m |
| \(p_{max}\) | Highest pressure (uniform wear, at the inner radius) | Pa |
| \(P\) | Power at the speed (uniform wear) | W |
Method and standards
Integration of friction over the annulus.
Where it is used
- Clutch selection and checks.
- Machine design examinations.
Common mistakes
- Counting one face for a single plate.
- Designing on uniform pressure.
Assumptions and limits
- Flat annular faces. With an inner radius of 0 the uniform-wear peak pressure is unbounded and is not shown.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 16 (disc clutches, uniform wear and uniform pressure)
Questions and answers
4 kN on a 250/150 mm single-plate clutch (two faces), μ 0.3?
Uniform wear 240 N·m; uniform pressure 245 N·m.
Why two theories?
New linings have uniform pressure; once worn, uniform wear, which gives less torque.
How many surfaces does a single plate have?
Two: one each side.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.