Worked example
Example: 20 T, m 4, 40 mm, 15 kW at 1,450 rpm, cut. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Power transmitted | 15.000 kW |
| Pinion speed | 1,450.0 rpm |
| Pinion teeth | 20.000 - |
| Module | 4.0000 mm |
| Face width | 40.000 mm |
| Lewis form factor (from z and pressure angle) | 0.32200 - |
| Velocity factor form | Cut or milled teeth: 6.1/(6.1 + v) |
Applying the formula below gives:
| Result | Value |
|---|---|
| Pitch diameter | 80.000 mm |
| Pitch-line velocity | 6.0737 m/s |
| Tangential load | 2.4696 kN |
| Velocity factor | 0.50108 |
| Bending stress | 95.665 MPa |
Open this example in the calculator and change any input.
Formula
\(\sigma = \frac{F_t}{K_vbmY}, \quad F_t = \frac{P}{v}, \quad v = \pi dN, \quad K_v = \frac{6.1}{6.1 + v}\ (\text{cut}), \quad \frac{3.56}{3.56 + \sqrt{v}}\ (\text{hobbed or shaped}), \quad \frac{5.56}{5.56 + \sqrt{v}}\ (\text{ground})\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(P\) | Power transmitted | W |
| \(N\) | Pinion speed | 1/s |
| \(z\) | Pinion teeth | - |
| \(m\) | Module | m |
| \(b\) | Face width | m |
| \(Y\) | Lewis form factor (from z and pressure angle) | - |
| \(\text{velocity}\) | Velocity factor form | - |
| \(d\) | Pitch diameter | m |
| \(v\) | Pitch-line velocity | m/s |
| \(F_t\) | Tangential load | N |
| \(K_v\) | Velocity factor | - |
| \(\sigma\) | Bending stress | Pa |
Method and standards
Lewis equation.
Where it is used
- Preliminary gear sizing.
- Checking a replacement gear.
Common mistakes
- Using the Lewis result as a final rating.
- Y for the wrong pressure angle.
Assumptions and limits
- One tooth carries the load at the tip.
References
- Budynas and Nisbett
- Shigley's Mechanical Engineering Design
- 10th ed. (McGraw-Hill, 2015)
- ch. 14 (Lewis bending equation and velocity factors)
Questions and answers
What does the Lewis equation assume?
The tooth is a cantilever loaded at its tip with the whole tangential load; the form factor Y captures the tooth shape.
Why a velocity factor?
Dynamic loads from tooth errors grow with speed; better-finished gears tolerate more.
What do the defaults represent?
A 20-tooth, 4 mm module pinion 40 mm wide carrying 15 kW at 1,450 rpm.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.