Worked example
Example: 2 kN·m, six 12 mm bolts on 160 mm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Torque transmitted | 2,000.0 N·m |
| Number of bolts | 6.0000 - |
| Bolt pitch circle diameter | 160.00 mm |
| Bolt diameter (shank in shear) | 12.000 mm |
| Allowable shear stress of the bolts | 60.000 MPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Force on each bolt | 4.1667 kN |
| Shear stress in the bolts | 36.841 MPa |
| Bolt diameter needed | 9.4032 mm |
| Torque the bolts carry at the allowable stress | 3,257.2 N·m |
Open this example in the calculator and change any input.
Formula
\(F_b = \frac{2T}{n D_b}, \quad \tau = \frac{F_b}{\pi d^2/4}, \quad T_{max} = n\, \frac{\pi d^2}{4}\, \tau_a\, \frac{D_b}{2}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(T\) | Torque transmitted | N·m |
| \(n\) | Number of bolts | - |
| \(D_b\) | Bolt pitch circle diameter | m |
| \(d\) | Bolt diameter (shank in shear) | m |
| \(\tau_a\) | Allowable shear stress of the bolts | Pa |
| \(F_b\) | Force on each bolt | N |
| \(\tau\) | Shear stress in the bolts | Pa |
| \(d_{min}\) | Bolt diameter needed | m |
| \(T_{max}\) | Torque the bolts carry at the allowable stress | N·m |
Method and standards
Torque shared equally by the bolts.
Where it is used
- Coupling selection and checks.
- Machine design examinations.
Common mistakes
- Diameter instead of radius.
- Using the thread root for fitted bolts.
Assumptions and limits
- Equal sharing. A shear stress above the allowable is flagged.
- Bearing (crushing) of the bolts on the flange and the flange and hub strength are not checked.
References
- Rigid flange coupling
- fitted bolts in shear (textbook machine design)
Questions and answers
Six 12 mm bolts on a 160 mm circle carrying 2 kN·m?
4167 N per bolt, 36.8 MPa.
Fitted or clearance bolts?
Fitted (reamed) bolts work in shear; clearance bolts rely on friction.
Why a larger pitch circle?
It lowers the bolt force for the same torque.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.