Worked example
Example: 300/240 mm, 12.5°, 2 kN. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Axial (engaging) force | 2,000.0 N |
| Friction coefficient | 0.25000 - |
| Semi-cone angle | 12.500 ° |
| Outer radius | 150.00 mm |
| Inner radius | 120.00 mm |
| Required torque (for the force) | 200.00 N·m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Mean radius | 135.00 mm |
| Torque capacity (uniform wear) | 311.87 N·m |
| Axial force for the required torque | 1,282.6 N |
| Maximum pressure (at inner radius) | 88.419 kPa |
Open this example in the calculator and change any input.
Formula
\(T = \frac{\mu Wr_m}{\sin\alpha}, \quad r_m = \frac{r_o + r_i}{2}, \quad p_{max} = \frac{W}{2\pi r_i(r_o - r_i)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(W\) | Axial (engaging) force | N |
| \(\mu\) | Friction coefficient | - |
| \(\alpha\) | Semi-cone angle | rad |
| \(r_o\) | Outer radius | m |
| \(r_i\) | Inner radius | m |
| \(T_{req}\) | Required torque (for the force) | N·m |
| \(r_m\) | Mean radius | m |
| \(T\) | Torque capacity (uniform wear) | N·m |
| \(W_{req}\) | Axial force for the required torque | N |
| \(p_{max}\) | Maximum pressure (at inner radius) | Pa |
Method and standards
Uniform-wear clutch theory.
Where it is used
- Machine tool and winch clutches.
- Teaching.
Common mistakes
- Using uniform pressure for worn clutches.
- Very small cone angles.
Assumptions and limits
- Uniform wear; rigid cone; force for steady (non-slipping) engagement.
- p_max is not compared with the lining's allowable pressure. Engaging while slipping needs W(sin α + μ cos α)/sin α.
- A semi-cone angle below about 12.5° is flagged.
References
- Rattan
- Theory of Machines
- 4th ed. (McGraw-Hill, 2014); Bhandari
- Design of Machine Elements
- 4th ed. (McGraw-Hill, 2017) (cone clutch, uniform wear)
- Budynas and Nisbett
- Shigley's Mechanical Engineering Design
- 10th ed. (McGraw-Hill, 2015)
- ch. 16
Questions and answers
Why does a cone multiply torque?
The wedge raises the normal force on the friction surface by 1/sin α for the same axial push.
Why not make α very small?
Below about 12.5° the cone tends to jam and needs force to release.
What do the defaults represent?
A cone clutch 300/240 mm with a 12.5° semi-angle and 2 kN engaging force.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.