FireCADCalc

Straight Bevel Gear Tooth Forces

Tangential, radial and axial forces on a straight bevel gear from torque, mean pitch diameter, pressure angle and pitch cone angle, for shaft and bearing design.

Inputs

Examples: 100 N·m, 90 mm mean, 20°, pinion of a 1:3 pairSame pair, gear: 300 N·m, 270 mm, 71.57°1:1 mitre pair, 50 N·m, 60 mm

Results

The radial force on one gear is the axial force on its mate (shafts at 90°).

Tangential force1.6667kN
Radial force W_t tan φ cos γ0.42894kN
Axial force W_t tan φ sin γ0.42894kN

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 100 N·m, 90 mm mean, 20°, pinion of a 1:3 pair. The inputs, in the units selected above:

InputValue
Torque on the gear100.00 N·m
Mean (mid-face) pitch diameter90.000 mm
Pressure angle20.000 °
Pitch cone angle of this gear18.435 °

Applying the formula below gives:

ResultValue
Tangential force2.2222 kN
Radial force W_t tan φ cos γ0.76732 kN
Axial force W_t tan φ sin γ0.25577 kN

Open this example in the calculator and change any input.

Formula

\(W_t = \frac{2T}{d_{av}}, \quad W_r = W_t \tan\phi \cos\gamma, \quad W_a = W_t \tan\phi \sin\gamma\)

Variables

Symbol Meaning SI unit
\(T\) Torque on the gear N·m
\(d_{av}\) Mean (mid-face) pitch diameter m
\(\phi\) Pressure angle rad
\(\gamma\) Pitch cone angle of this gear rad
\(W_t\) Tangential force N
\(W_r\) Radial force W_t tan φ cos γ N
\(W_a\) Axial force W_t tan φ sin γ N

Method and standards

Force resolution on the pitch cone.

Where it is used

  • Right-angle drives.
  • Bearing selection.

Common mistakes

  • Using outer pitch diameter.
  • Swapping pinion and gear cone angles.

Assumptions and limits

  • Straight teeth, friction neglected.

References

  • Shigley's Mechanical Engineering Design (Budynas and Nisbett)
  • ch. 13 (bevel gear force analysis)

Questions and answers

What is the pitch cone angle of a 1:3 pair at 90°?

tan γ = 1/3 for the pinion: 18.43°; the gear has 71.57°.

100 N·m on a 90 mm mean diameter pinion?

W_t 2222 N, radial 767 N, axial 256 N.

Why mean diameter?

The resultant acts at the middle of the face width.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.