FireCADCalc

Torque Wrench Extension (Crowfoot) Correction

Setting of a torque wrench used with an extension or crowfoot adapter so the fastener gets the torque wanted, from the wrench length and extension length.

Inputs

Examples: 200 N·m, 400 mm wrench, 60 mm crowfoot60 N·m, 300 mm, 100 mm extension500 N·m, 800 mm, 50 mm folded back

Results

An extension at 90° to the handle needs no correction.

Setting on the wrench T_a L/(L + E)533.33N·m
Correction ratio1.0667

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 200 N·m, 400 mm wrench, 60 mm crowfoot. The inputs, in the units selected above:

InputValue
Torque wanted at the fastener200.00 N·m
Wrench length (hand grip to square drive)400.00 mm
Extension length in line (negative if folded back)60.000 mm

Applying the formula below gives:

ResultValue
Setting on the wrench T_a L/(L + E)173.91 N·m
Correction ratio0.86957

Open this example in the calculator and change any input.

Formula

\(T_w = T_a\, \frac{L}{L + E}\)

Variables

Symbol Meaning SI unit
\(T_a\) Torque wanted at the fastener N·m
\(L\) Wrench length (hand grip to square drive) m
\(E\) Extension length in line (negative if folded back) m
\(T_w\) Setting on the wrench T_a L/(L + E) N·m
\(L/(L + E)\) Correction ratio -

Method and standards

Moments about the fastener.

Where it is used

  • Flange and engine bolting.
  • Maintenance.

Common mistakes

  • Measuring L from the wrong point.
  • Correcting for a 90° extension.

Assumptions and limits

  • Only in-line (E positive) or folded-back (E negative) extensions are covered. For an extension at an angle α to the wrench, use the effective extension E cos α in place of E; at 90° no correction is needed.

  • Extension in line with the wrench.

References

  • Moment balance about the fastener

Questions and answers

200 N·m wanted with a 400 mm wrench and a 60 mm crowfoot?

Set the wrench to 173.9 N·m.

At 90°?

No correction: the extension adds no lever arm.

Folded back?

Enter the extension as negative; the setting rises.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.