Worked example
Example: Module 4, 20 and 60 teeth, 20°. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Module | 4.0000 mm |
| Teeth on the pinion | 20.000 - |
| Teeth on the gear | 60.000 - |
| Pressure angle | 20.000 ° |
Applying the formula below gives:
| Result | Value |
|---|---|
| Pitch diameter of the pinion m z₁ | 80.000 mm |
| Pitch diameter of the gear | 240.00 mm |
| Centre distance (d₁ + d₂)/2 | 160.00 mm |
| Tip diameter of the pinion (addendum m) | 88.000 mm |
| Root diameter of the pinion (dedendum 1.25 m) | 70.000 mm |
| Base circle diameter of the pinion | 75.175 mm |
| Circular pitch π m | 12.566 mm |
| Speed ratio z₂/z₁ | 3.0000 |
Open this example in the calculator and change any input.
Formula
\(d = m z, \quad a = \frac{m (z_1 + z_2)}{2}, \quad d_a = d + 2m, \quad d_f = d - 2.5m, \quad d_b = d \cos\phi\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(m\) | Module | m |
| \(z_1\) | Teeth on the pinion | - |
| \(z_2\) | Teeth on the gear | - |
| \(\phi\) | Pressure angle | rad |
| \(d_1\) | Pitch diameter of the pinion m z₁ | m |
| \(d_2\) | Pitch diameter of the gear | m |
| \(a\) | Centre distance (d₁ + d₂)/2 | m |
| \(d_{a1}\) | Tip diameter of the pinion (addendum m) | m |
| \(d_{f1}\) | Root diameter of the pinion (dedendum 1.25 m) | m |
| \(d_{b1}\) | Base circle diameter of the pinion | m |
| \(p\) | Circular pitch π m | m |
| \(i\) | Speed ratio z₂/z₁ | - |
Method and standards
Standard involute gear geometry.
Where it is used
- Gearbox layout.
- Replacing a worn gear.
Common mistakes
- Mixing module and diametral pitch.
- Ignoring undercut.
Assumptions and limits
- Standard teeth, no profile shift.
References
- ISO 53 / ISO 54 standard basic rack (addendum m, dedendum 1.25 m)
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 13
Questions and answers
A 4 mm module, 20 and 60 teeth: what centre distance?
Pitch diameters 80 and 240 mm, centre distance 160 mm, ratio 3.
What is the module?
Pitch diameter divided by the number of teeth, in mm.
Why avoid very small pinions?
Below about 17 teeth at 20° the cutter undercuts the tooth root.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.