Worked example
Example: 50/200 mm at 1,500 rpm, 45°. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Crank radius | 50.000 mm |
| Connecting rod length | 200.00 mm |
| Crank speed | 1,500.0 rpm |
| Crank angle from inner dead centre | 45.000 ° |
Applying the formula below gives:
| Result | Value |
|---|---|
| Piston displacement from inner dead centre | 17.794 mm |
| Piston velocity | 6.5511 m/s |
| Piston acceleration (m/s²) | 877.41 |
| Mean piston speed | 5.0000 m/s |
| Connecting rod angle | 10.182 ° |
Open this example in the calculator and change any input.
Formula
\(x = r(1 - \cos\theta) + l - \sqrt{l^2 - r^2\sin^2\theta}, \quad v = r\omega\left(\sin\theta + \frac{\sin\theta\cos\theta}{\sqrt{n^2 - \sin^2\theta}}\right)\)
\(a = r\omega^2\left(\cos\theta + \frac{n^2\cos 2\theta + \sin^4\theta}{(n^2 - \sin^2\theta)^{3/2}}\right), \quad \bar v = 4rN, \quad \sin\phi = \frac{\sin\theta}{n}, \quad \omega = 2\pi N,\ n = \frac{l}{r}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(r\) | Crank radius | m |
| \(l\) | Connecting rod length | m |
| \(N\) | Crank speed | 1/s |
| \(\theta\) | Crank angle from inner dead centre | rad |
| \(x\) | Piston displacement from inner dead centre | m |
| \(v\) | Piston velocity | m/s |
| \(a\) | Piston acceleration | m/s² |
| \(\omega\) | Crank angular speed 2πN | rad/s |
| \(n\) | Rod ratio l/r | - |
| \(\bar v\) | Mean piston speed | m/s |
| \(\phi\) | Connecting rod angle | rad |
Method and standards
Exact slider–crank relations.
Where it is used
- Reciprocating compressor and pump design.
- Engine dynamics and inertia forces.
Common mistakes
- Measuring angle from bottom dead centre.
- Using the approximation for short rods.
Assumptions and limits
- Rigid links; constant crank speed.
- The acceleration is given in m/s² in every unit system.
References
- Rattan
- Theory of Machines
- 4th ed. (McGraw-Hill, 2014); Bhandari
- Design of Machine Elements
- 4th ed. (McGraw-Hill, 2017) (slider–crank: exact displacement, velocity and acceleration)
Questions and answers
Why is piston acceleration largest at top dead centre?
The crank and rod angularities add there; at bottom dead centre they partly cancel.
What is the rod ratio?
l/r, usually 3.5–4.5 in engines and compressors; shorter rods raise secondary forces.
What do the defaults represent?
A 50 mm crank and 200 mm rod at 1,500 rpm, 45° past inner dead centre.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.