Worked example
Example: 50 kN, 25 mm pin, 30 mm eye. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Load on the joint | 50.000 kN |
| Pin diameter | 25.000 mm |
| Thickness of the eye (middle plate) | 30.000 mm |
| Allowable shear stress of the pin | 80.000 MPa |
| Allowable bearing stress | 120.00 MPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Shear stress in the pin F/(2 π d²/4) | 50.930 MPa |
| Bearing stress on the eye F/(d t) | 66.667 MPa |
| Pin diameter needed for shear | 19.947 mm |
| Pin diameter needed for bearing | 13.889 mm |
Open this example in the calculator and change any input.
Formula
\(\tau = \frac{F}{2\,\pi d^2/4}, \quad \sigma_b = \frac{F}{d\, t}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(F\) | Load on the joint | N |
| \(d\) | Pin diameter | m |
| \(t\) | Thickness of the eye (middle plate) | m |
| \(\tau_a\) | Allowable shear stress of the pin | Pa |
| \(\sigma_{b,a}\) | Allowable bearing stress | Pa |
| \(\tau\) | Shear stress in the pin F/(2 π d²/4) | Pa |
| \(\sigma_b\) | Bearing stress on the eye F/(d t) | Pa |
| \(d_s\) | Pin diameter needed for shear | m |
| \(d_b\) | Pin diameter needed for bearing | m |
Method and standards
Direct shear and bearing.
Where it is used
- Linkages, cylinders and lifting gear.
- Machine design examinations.
Common mistakes
- Single-shear area for a clevis.
- Ignoring eye tear-out.
Assumptions and limits
- Static load; double shear with the eye as the middle plate.
- Bearing on the fork plates, bending of the pin and tear-out of the eye are not checked.
References
- Direct shear and projected-area bearing (textbook strength of materials)
Questions and answers
A 25 mm pin carrying 50 kN in double shear?
50.9 MPa shear; bearing on a 30 mm eye 66.7 MPa.
Why double shear?
The pin is cut on two planes, one each side of the middle plate.
What about bending?
Long pins in loose clevises bend; check them separately.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.