Worked example
Example: 25 mm lift over 120° at 300 rpm, 1.5 kg. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Lift (rise) | 25.000 mm |
| Cam angle for the rise | 120.00 ° |
| Cam speed | 300.00 rpm |
| Mass of the follower train (for the force) | 1.5000 kg |
Applying the formula below gives:
| Result | Value |
|---|---|
| Peak velocity π h ω/(2β) | 0.58905 m/s |
| Peak acceleration π² h ω²/(2β²) | 27.758 m/s² |
| Inertia force m a_max | 0.041637 kN |
| Time for the rise | 0.066667 s |
Open this example in the calculator and change any input.
Formula
\(y = \frac{h}{2}\left(1 - \cos\frac{\pi\theta}{\beta}\right), \quad v_{max} = \frac{\pi h \omega}{2\beta}, \quad a_{max} = \frac{\pi^2 h \omega^2}{2\beta^2}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(h\) | Lift (rise) | m |
| \(\beta\) | Cam angle for the rise | rad |
| \(N\) | Cam speed | 1/s |
| \(m\) | Mass of the follower train (for the force) | kg |
| \(v_{max}\) | Peak velocity π h ω/(2β) | m/s |
| \(a_{max}\) | Peak acceleration π² h ω²/(2β²), in m/s² | m/s² |
| \(F\) | Inertia force m a_max | N |
| \(t\) | Time for the rise | s |
Method and standards
Derivatives of the SHM profile.
Where it is used
- Cam and valve gear design.
- Theory of machines examinations.
Common mistakes
- Degrees for β.
- rpm for ω.
Assumptions and limits
- Rigid follower train.
- F is the inertia force alone; the return spring must also carry its preload and any external load on the follower.
- The peak acceleration is always in m/s², whatever the unit system.
References
- Simple harmonic follower motion y = (h/2)(1 − cos(πθ/β)) (textbook theory of machines)
Questions and answers
25 mm lift over 120° at 300 rpm?
Peak velocity 0.59 m/s, acceleration 28 m/s².
Why does acceleration matter?
It sets the return spring force needed to keep the follower on the cam.
How to lower it?
A longer rise angle: acceleration falls with its square.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.