FireCADCalc

Steam or Gas Stripping Stages (Kremser)

Theoretical stages of a counter-current stripper with a straight equilibrium line from the liquid inlet and outlet and the stripping gas, by the Kremser equation.

Refinery and petrochemicalChemical and fertiliser

Inputs

Examples: Steam stripper S = 1.5Air stripper with some solute in air

Results

Stripping factor mV/L1.5000
Theoretical stages8.6971
Fraction stripped99.000%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Steam stripper S = 1.5. The inputs, in the units selected above:

InputValue
Solute in the liquid entering (mole fraction)0.10000 %
Solute in the liquid leaving0.001000 %
Solute in the stripping gas entering0 %
Equilibrium slope y = mx30.000 -
Stripping gas to liquid molar ratio0.050000 -

Applying the formula below gives:

ResultValue
Stripping factor mV/L1.5000
Theoretical stages8.6971
Fraction stripped99.000 %

Open this example in the calculator and change any input.

Formula

\(\frac{x_{in} - x_{out}}{x_{in} - y_{in}/m} = \frac{S^{N+1} - S}{S^{N+1} - 1}, \quad S = \frac{mV}{L}\)

Variables

Symbol Meaning SI unit
\(x_{in}\) Solute in the liquid entering (mole fraction) -
\(x_{out}\) Solute in the liquid leaving -
\(y_{in}\) Solute in the stripping gas entering -
\(m\) Equilibrium slope y = mx -
\(V/L\) Stripping gas to liquid molar ratio -
\(S\) Stripping factor mV/L -
\(N\) Theoretical stages -
\(\phi_S\) Fraction stripped -

Method and standards

Kremser stripping form solved for N.

Where it is used

  • Sour water and volatile organic stripping.
  • Deaerators and CO₂ strippers.

Common mistakes

  • Using the absorption factor.
  • Ignoring solute in the gas.

Assumptions and limits

  • Dilute; straight equilibrium; isothermal.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 13 (distillation)
  • Kremser equation for strippers

Questions and answers

What stripping factor is needed?

S above 1; around 1.4–2 gives a reasonable number of stages.

Why does the inlet gas matter?

Solute in the stripping gas sets a floor x = y_in/m below which the liquid cannot be stripped.

Is this the absorber equation turned round?

Yes, with A replaced by S = mV/L and liquid and gas swapped.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.