FireCADCalc

Absorber Theoretical Stages (Kremser Equation)

Number of theoretical stages of a counter-current absorber with a straight equilibrium line (y = mx) from the gas inlet and outlet and liquid inlet, by Kremser.

Sugar mill and cogenerationRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: Clean solvent, A = 1.5Lean solvent with solute, A = 1.25A below 1, modest recovery

Results

Dilute systems with straight operating and equilibrium lines; round the stages up and divide by the tray efficiency.

Absorption factor L/(mG)1.5000
Theoretical stages4.9139
Fraction of solute absorbed95.000%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Clean solvent, A = 1.5. The inputs, in the units selected above:

InputValue
Solute in the gas entering (mole fraction)2.0000 %
Solute in the gas leaving0.10000 %
Solute in the liquid entering0 %
Equilibrium slope y = mx1.2000 -
Liquid-to-gas molar ratio1.8000 -

Applying the formula below gives:

ResultValue
Absorption factor L/(mG)1.5000
Theoretical stages4.9139
Fraction of solute absorbed95.000 %

Open this example in the calculator and change any input.

Formula

\(N = \frac{\ln\left[\frac{y_{in} - m x_{in}}{y_{out} - m x_{in}}\left(1 - \frac{1}{A}\right) + \frac{1}{A}\right]}{\ln A}, \quad A = \frac{L}{mG}\)

Variables

Symbol Meaning SI unit
\(y_{in}\) Solute in the gas entering (mole fraction) -
\(y_{out}\) Solute in the gas leaving -
\(x_{in}\) Solute in the liquid entering -
\(m\) Equilibrium slope y = mx -
\(L/G\) Liquid-to-gas molar ratio -
\(A\) Absorption factor L/(mG) -
\(N\) Theoretical stages -
\(\phi\) Fraction of solute absorbed -

Method and standards

Kremser.

Where it is used

  • Scrubbers and absorbers.
  • Strippers (with the stripping form).

Common mistakes

  • Mass instead of molar L/G.
  • Non-linear equilibrium.

Assumptions and limits

  • Dilute, isothermal, straight lines.
  • For A within 10⁻⁶ of 1 the linear A = 1 form is used, which avoids a loss of precision in the general formula.

References

  • Kremser (1930) equation for counter-current stages with constant absorption factor A = L/(mG)

Questions and answers

2 % to 0.1 %, clean solvent, m 1.2, L/G 1.8?

A = 1.5: about 4.91 theoretical stages.

Why must A exceed a minimum?

With too little liquid the outlet target can never be reached.

A = 1?

A separate linear form applies; the calculator uses it.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.