FireCADCalc

Gilliland Correlation: Stages from Nmin, Rmin and R

Theoretical stages at a working reflux from Fenske minimum stages and Underwood minimum reflux, by the Molokanov equation fitted to Gilliland's correlation.

Distillery and ethanolRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: Nmin 8, Rmin 1.2, R 1.5Nmin 12, Rmin 2.0, R 3.0

Results

(R − Rmin)/(R + 1)0.12000
(N − Nmin)/(N + 1)0.53373
Theoretical stages18.302

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Nmin 8, Rmin 1.2, R 1.5. The inputs, in the units selected above:

InputValue
Minimum stages (Fenske)8.0000 -
Minimum reflux ratio1.2000 -
Operating reflux ratio1.5000 -

Applying the formula below gives:

ResultValue
(R − Rmin)/(R + 1)0.12000
(N − Nmin)/(N + 1)0.53373
Theoretical stages18.302

Open this example in the calculator and change any input.

Formula

\(\frac{N - N_{min}}{N + 1} = 1 - \exp\left[\frac{1 + 54.4\psi}{11 + 117.2\psi}\cdot\frac{\psi - 1}{\psi^{0.5}}\right], \quad \psi = \frac{R - R_{min}}{R + 1}\)

Variables

Symbol Meaning SI unit
\(N_{min}\) Minimum stages (Fenske) -
\(R_{min}\) Minimum reflux ratio -
\(R\) Operating reflux ratio -
\(\psi\) (R − Rmin)/(R + 1) -
\(Y\) (N − Nmin)/(N + 1) -
\(N\) Theoretical stages -

Method and standards

Perry's Eq. (13-30).

Where it is used

  • Short-cut column design.
  • Reflux–stages trade-off studies.

Common mistakes

  • Using for strongly non-ideal or azeotropic mixtures.
  • Mixing stage counts with and without the reboiler.

Assumptions and limits

  • Near-ideal mixtures; the correlation scatters about ±30 % in N, so read the stage count to the nearest whole stage or so, whatever the number of figures shown.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 13 (distillation)
  • Eq. (13-30)
  • Molokanov et al.
  • Int. Chem. Eng. 12(2): 209 (1972)

Questions and answers

What is the FUG method?

Fenske for Nmin, Underwood for Rmin, Gilliland for N at the chosen reflux.

Is the Molokanov fit good?

Perry's: it satisfies the end points and follows Gilliland's curve reasonably well.

What reflux is usual?

1.1–1.5 times the minimum.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.