FireCADCalc

Steam Distillation of an Immiscible Liquid

Steam needed per kilogram of an immiscible organic liquid distilled with live steam, from total pressure, its vapour pressure and molar mass (Dalton's law).

Refinery and petrochemicalChemical and fertiliserFood, dairy and textile

Inputs

Examples: Organic M 154, 8 kPa at still temperatureVacuum 30 kPa

Results

The still runs where p_A + p_w = P, below the boiling points of both liquids; find that temperature from both vapour pressure curves.

Partial pressure of steam93.325kPa
Steam per kg of organic1.7058kg/kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Organic M 154, 8 kPa at still temperature. The inputs, in the units selected above:

InputValue
Total pressure101.33 kPa
Vapour pressure of the organic at the still temperature8.0000 kPa
Molar mass of the organic154.00 kg/kmol
Vaporisation efficiency (saturation of steam)80.000 %

Applying the formula below gives:

ResultValue
Partial pressure of steam93.325 kPa
Steam per kg of organic1.7058 kg/kg

Open this example in the calculator and change any input.

Formula

\(\frac{\dot m_s}{\dot m_A} = \frac{P - p_A^s}{E\,p_A^s}\cdot\frac{M_w}{M_A}\)

Variables

Symbol Meaning SI unit
\(P\) Total pressure Pa
\(p_A^s\) Vapour pressure of the organic at the still temperature Pa
\(M_A\) Molar mass of the organic kg/kmol
\(E\) Vaporisation efficiency (saturation of steam) -
\(p_w\) Partial pressure of steam Pa
\(\dot m_s/\dot m_A\) Steam per kg of organic kg/kg
\(M_w\) Molar mass of water 18.015 kg/kmol

Method and standards

Dalton's law with a vaporisation efficiency.

Where it is used

  • Essential oil and fatty acid deodorising.
  • Solvent recovery.

Common mistakes

  • Using total instead of partial pressure.
  • Assuming the steam is saturated with the organic.

Assumptions and limits

  • Immiscible liquids; ideal gas.

References

  • Dalton's law of partial pressures for immiscible liquids (each exerts its own vapour pressure)
  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 13 (distillation)
  • vaporisation efficiency

Questions and answers

Why does it work below 100 °C?

Two immiscible liquids boil when their vapour pressures together reach the total pressure.

What is vaporisation efficiency?

The degree to which the steam leaving is saturated with the organic; 0.6–0.9 is typical.

Why vacuum helps?

Lower total pressure cuts p_w for the same p_A, so less steam per kilogram.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.