FireCADCalc

Actual Trays and Column Height from Theoretical Stages

Actual trays from theoretical stages and overall tray efficiency, and the tower height from tray spacing and the top and bottom allowances.

Distillery and ethanolRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: 20 stages at 75 %, 600 mmEthanol rectifier 35 stages at 80 %, 450 mm

Perry's Table 14-12: ethanol–water sieve trays 75–85 %.

Results

Actual trays (rounded up)27.000
Tower height (tangent to tangent)18.800m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 20 stages at 75 %, 600 mm. The inputs, in the units selected above:

InputValue
Theoretical stages in the column (reboiler excluded)20.000 -
Overall tray efficiency75.000 %
Tray spacing600.00 mm
Top allowance1.2000 m
Bottom (sump) allowance2.0000 m

Applying the formula below gives:

ResultValue
Actual trays (rounded up)27.000
Tower height (tangent to tangent)18.800 m

Open this example in the calculator and change any input.

Formula

\(N_a = \left\lceil\frac{N_t}{E_O}\right\rceil, \quad H = (N_a - 1)S_T + H_{top} + H_{bot}\)

Variables

Symbol Meaning SI unit
\(N_t\) Theoretical stages in the column (reboiler excluded) -
\(E_O\) Overall tray efficiency -
\(S_T\) Tray spacing m
\(H_{top}\) Top allowance m
\(H_{bot}\) Bottom (sump) allowance m
\(N_a\) Actual trays (rounded up) -
\(H\) Tower height (tangent to tangent) m

Method and standards

Overall efficiency definition and tray stacking.

Where it is used

  • Preliminary tower layout.

Common mistakes

  • Dividing the reboiler stage by efficiency.
  • Forgetting feed and manway spacing.

Assumptions and limits

  • Uniform spacing; allowances from the user.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 14 (equipment for distillation and gas absorption)
  • overall efficiency and Table 14-12 (representative tray efficiencies)

Questions and answers

Why exclude the reboiler?

It is a theoretical stage but not a tray.

What efficiency is usual?

60–90 % for most distillations; absorbers can be far lower.

Why round up?

Trays are whole; round up after dividing by efficiency.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.