FireCADCalc

Single-Stage and Cross-Current Liquid Extraction

Fraction of solute left in the raffinate after one extraction stage and after n cross-current stages with equal solvent, for a constant distribution coefficient.

Distillery and ethanolRefinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: K 3, S/F 1, three stagesK 0.8, S/F 2, five stages

Results

Immiscible solvents and a constant K_D on a solute-free basis. Counter-current stages (Kremser) use the same solvent more effectively.

Extraction factor, single stage3.0000
Fraction left after one stage (all solvent)25.000%
Fraction left after n cross-current stages12.500%
Recovery with n stages87.500%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: K 3, S/F 1, three stages. The inputs, in the units selected above:

InputValue
Distribution coefficient (extract/raffinate, same basis)3.0000 -
Total solvent-to-feed ratio1.0000 -
Number of cross-current stages3.0000 -

Applying the formula below gives:

ResultValue
Extraction factor, single stage3.0000
Fraction left after one stage (all solvent)25.000 %
Fraction left after n cross-current stages12.500 %
Recovery with n stages87.500 %

Open this example in the calculator and change any input.

Formula

\(E = K_D\frac{S}{F}, \quad r_1 = \frac{1}{1 + E}, \quad r_n = \left(1 + \frac{E}{n}\right)^{-n}\)

Variables

Symbol Meaning SI unit
\(K_D\) Distribution coefficient (extract/raffinate, same basis) -
\(S/F\) Total solvent-to-feed ratio -
\(n\) Number of cross-current stages -
\(E\) Extraction factor, single stage -
\(r_1\) Fraction left after one stage (all solvent) -
\(r_n\) Fraction left after n cross-current stages -
\(1 - r_n\) Recovery with n stages -

Method and standards

Stage balances.

Where it is used

  • Laboratory and batch extractions.
  • Comparing cross-current with counter-current schemes.

Common mistakes

  • Using K_D on a different concentration basis.
  • Ignoring solvent solubility in the feed.

Assumptions and limits

  • Immiscible phases; equilibrium stages.
  • The total solvent is divided equally among the n stages (S/n each), which is what the form (1 + E/n)^−n assumes; unequal splits extract less.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 15 (extraction factor; cross-current extraction)

Questions and answers

Why split the solvent?

Several small contacts extract more than one large one: with E = 3, one stage leaves 25 %, three stages of one-third each leave 12.5 %.

What is the extraction factor?

K_D·S/F: how much of the solute the solvent can carry compared with the feed.

What do the defaults represent?

A solute with K_D 3 extracted with an equal mass of solvent in one stage or split over three.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.